Use and Care Manual

5
3 Description
3.1 Overview of the product 1
@ Side handle
; Keyless chuck
= Torque and drilling mode selector ring
% Gear selector switch
& Forward/reverse selector switch with safety
lock
( Control switch (with electronic speed
control)
) Grip
+ Light to illuminate the work area
§ Belt hook (optional)
/ Liion battery
: Battery release button
∙ State of charge and fault display (Li-ion
battery)
3.2 Intended use
The product described is a hand-held cordless drill / driver. It is designed to be used for driving and removing
screws and for drilling in steel, wood and plastic.
▶ Use only Hilti Liion batteries of the B 18 series with this product.
▶ Use only the Hilti battery chargers from the C4/36 series for these batteries.
3.3 ATC
The power tool is equipped with the ATC (Active Torque Control) quick-acting electronic cut-out.
If the accessory tool sticks or stalls, the power tool will suddenly pivot about its own axis in the opposite
direction. ATC detects this sudden pivoting movement of the power tool and switches the tool off immediately.
Note
For ATC to function correctly, the power tool must be free to pivot.
After the power tool has cut out due to ATC, switch it back on again by releasing the control switch
for a moment and then pressing the switch again.
3.4 Liion battery display
The charge status of the Li-ion battery and malfunctions of the power tool are indicated by the display on
the Liion battery. The charge status of the Liion battery is displayed after pressing one of the two battery
release buttons.
Status Meaning
4 LEDs light. • Charge status: 75 % to 100 %
3 LEDs light. • Charge status: 50 % to 75 %
2 LEDs light. • Charge status: 25 % to 50 %
1 LED lights. • Charge status: 10 % to 25 %
1 LED blinks, the power tool is ready for use. • Charge status: < 10 %
1 LED blinks, the power tool is not ready for use. • The battery has overheated or is completely
discharged.
4 LEDs blink, the power tool is not ready for use. • The power tool is overloaded or has overheated.
Note
Battery charge status cannot be displayed while the control switch is pressed and for up to 5 seconds
after releasing the control switch.
If the battery display LEDs blink, please observe the instructions given in the Troubleshooting section.
3.5 Items supplied
Drill / driver, side handle, operating instructions.
Note
Spare parts, consumables and accessories approved by Hilti for use with the product can be found at
your local Hilti Center or online at: www.hilti.com
Printed: 06.11.2015 | Doc-Nr: PUB / 5255075 / 000 / 00