Use and Care Manual

5.4 Fitting the side handle 5

CAUTION

Risk of injury. The drill/driver may start inadvertently.

▶ Make sure that the forward / reverse switch is in the middle position (safety lock engaged) or that

the battery has been removed from the drill / driver.

▶ Fit the side handle.

5.5 Adjusting the side handle 6

▶ Adjust the side handle to the desired position.

5.6 Selecting the gear 7

▶ Select the desired gear by adjusting the two gear selector switches.

5.7 Setting forward or reverse rotation 8

Note

An interlock prevents switching while the motor is running.

The control switch is locked when the forward/reverse switch is in the middle position (safety lock).

▶ Set the forward/reverse switch to the desired direction of rotation.

5.8 Fitting the accessory tool

1. Set the forward/reverse switch to the middle position or remove the battery from the power tool.

2. Check that the connection end of the accessory tool is clean. Clean the connection end if necessary.

3. Open the keyless chuck.

4. Insert the accessory tool in the keyless chuck and then turn the chuck firmly by hand until tight and

several clicks are heard.

5. Check that the accessory tool is held securely.

5.9 Drilling

Set the torque and operating mode selector ring to the symbol.

2. Set the forward/reverse switch to the “forward” position.

5.10 Screwdriving

1. Set the torque and operating mode selector ring to the required torque.

2. Set the forward/reverse switch to the desired direction of rotation.

5.11 Switching on

▶ Press the control switch.

Note

The running speed can be controlled smoothly right up to maximum speed by varying how far the

control switch is pressed in.

5.12 Switching off

▶ Release the control switch.

5.13 Removing the accessory tool

1. Set the forward/reverse switch to the middle position or remove the battery from the power tool.

2. Open the keyless chuck.

3. Pull the accessory tool out of the keyless chuck.

Printed: 06.11.2015 | Doc-Nr: PUB / 5255075 / 000 / 00