Use and Care Manual
1
1 Information about the documentation
1.1 Conventions
1.1.1 Warning signs
The following warning signs are used:
General warning
1.1.2 Symbols
The following symbols are used:
Read the operating instructions before use.
Instructions for use and other useful information
Rated speed under no load
Revolutions per minute
Direct current (DC)
Drilling without hammering
Active Torque Control (ATC)
1.1.3 Typographical emphasis
The following typographical features are used to emphasize important passages in the technical documen-
tation about your drill/driver:
1
These numbers refer to the corresponding illustrations.
1
The numbering in the illustrations reflects the order of the work steps and may deviate from the
numbering in the text.
1.2 About this documentation
▶ Read these operating instructions before the product is used or operated for the first time. This is a is a
prerequisite for safe, trouble-free handling and use of the product.
▶ Observe the safety instructions and warnings printed in this documentation and on the tool.
▶ Always keep the operating instructions with the tool and make sure that the operating instructions are
with the tool when it is given to other persons.
1.3 Product information
Hilti products are designed for professional use and may be operated, serviced and maintained only by
trained, authorized personnel. This personnel must be informed of any particular hazards that may be
encountered. The product and its ancillary equipment may present hazards when used incorrectly by
untrained personnel or when used not as directed.
The type designation and serial number are printed on the type identification plate.
▶ Write down the serial number in the table below. You will be required to state the product details when
contacting Hilti Service or your local Hilti organization to enquire about the product.
Product information
Drill/driver SF 10WA18
Generation 02
Serial no.
Printed: 06.11.2015 | Doc-Nr: PUB / 5255075 / 000 / 00