Operating Instruction SR 6-A22 (01)

12 English 2186515
*2186515*
5.4 Installing the scaffold hook (accessory) 2
1. Engage the transport lock.
2. Install the scaffold hook.
5.5 Inserting the saw blade 3
Use only saw blades with a 1/2" connection end.
1. Activate the transport lock or separate the battery from the power tool.
2. Check that the connection end of the accessory tool is clean and lightly
greased. Clean it and grease it if necessary.
3. Push the locking lever up as far as it will go and hold it in this position.
4. Push the saw blade into the chuck from in front.
5. Allow the locking lever to return to its original position.
6. Grip and pull the saw blade to check that it is locked in position.
5.6 Installing the dust removal adapter (accessory) 4
1. Pull the contact shoe out.
2. Set the dust removal adapter on the contact shoe mount.
3. Insert the lightly greased contact shoe fully into the guide.
6 Operation
Observe the safety instructions and warnings in this documentation and on
the product.
6.1 Guiding the saw 5
1. Hold the saw by the grips provided for the purpose.
2. Guide the saw to the workpiece.
3. Guide the saw forward and back.
▶ If you press the saw against the workpiece there is a risk of the saw
blade breaking and causing injuries.
6.2 Sawing 6
WARNING
Risk of injury by defective scaffold hook! A falling tool could injure you or
others.
▶ Before starting work, check that the scaffold hook is secure and undam-
aged.
1. Disengage the transport lock and press the control switch.
▶ The graphics section illustrates various ways of guiding the saw
effectively.
2. Release the control switch when you finish the cut.