X-PT 5 English Printed: 30.03.
Printed: 30.03.
1 Overview of the items available 1.1 Technical description English Printed: 30.03.
Item Description Length B Pole tool 1.55 m (5 ft) A Pole tool 1 2 3 4 Weight 2.16 m (7 ft) 2.1 kg (4.63 lb) 1.8 kg (3.97 lb) Tool holder Total length with DX 5 tool: ? 0.51 m (1 11/16 ft) 0.8 kg (1.76 lb) Tubular section Tubular section 0.93 m (3 ft) 0.7 kg (1.54 lb) Grip section 0.31 m (1 ft) 0.48 m (1 9/16 ft) 0.7 kg (1.54 lb) 0.3 kg (0.66 lb) 1.2 Selection table Item Part Tool holder 2 3 4 No. of parts in version 1.52 m (5 ft) No. of parts in version 2.13 m (7 ft) No.
3 Assembly 3.1 Assembling the tubular sections and tool holder Screw the tubular sections and tool holder together, tightening the joints by hand only, without use of tools. 3.2 Assembling the tubular sections and grip section Screw the tubular sections and grip section together. 3.3 Opening the retaining bar Open the retaining bar by releasing the screw knob. English Printed: 30.03.
3.4 Fitting the tool Fit the tool. 3.5 Securing the tool Secure the tool with the retaining bar and tighten the screw knob. 3.6 Position of the trigger lever Note that the trigger lever must be positioned in front of the trigger. 4 English Printed: 30.03.
4 Operation 4.1 Loading and using the tool The instructions contained in the operating instructions for the tool, concerning loading and use of the tool, must be observed. English Printed: 30.03.
4.2 Fastening accessories Note Never press the tool against the working surface at an angle. Always work at right angles to the surface into which the fasteners are to be driven. Hold the tool with the extension at right angles to the surface into which the fasteners are to be driven. Press the nose of the tool against the surface. Pull the trigger. 4.3 Grip section The grip section can be rotated at any time to bring it into a comfortable working position. 6 English Printed: 30.03.
4.4 Reloading Load the tool after lowering the pole tool. 4.5 Do not swing the tool down Note Do not swing the tool down while holding the pole at its lower end. 5 Disassembly Disassemble the tool following the assembly steps in the reverse order. English Printed: 30.03.
Printed: 30.03.
Printed: 30.03.
Hilti = registered trademark of Hilti Corp., Schaan Printed: 30.03.