Operating Instruction TE 30-A36 (03)

12 English 2173713
*2173713*
7 Transport and storage of cordless tools
Transport
CAUTION
Accidental starting during transport !
▶ Always transport your products with the batteries removed!
▶ Remove the battery.
▶ Never transport batteries in bulk form (loose, unprotected).
▶ Check the tool and batteries for damage before use after long periods of
transport.
Storage
CAUTION
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the tool and batteries in a place that is as cool and dry as possible.
▶ Never store batteries in direct sunlight, on heating units or behind a
window pane.
▶ Store the tool and batteries in a place where they cannot be accessed by
children or unauthorized persons.
▶ Check the tool and batteries for damage before use after long periods of
storage.
8 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable
to remedy the problem by yourself, please contact Hilti Service.
8.1 The combihammer is in working order.
Trouble or fault Possible cause Action to be taken
The battery runs
down more quickly
than usual.
Battery condition is not
optimal.
▶ Replace the battery.
The battery doesn’t
engage with an audi-
ble click.
The retaining lugs on the
battery are dirty.
▶ Clean the retaining
lugs and refit the
battery.
The control switch
can’t be pressed, i.e.
the switch is locked.
The forward / reverse
switch is in the middle
position.
▶ Push the forward /
reverse switch to the
right or left.
The drive spindle
doesn’t rotate.
The permissible operat-
ing temperature of the
combihammer’s elec-
tronics has been ex-
ceeded.
▶ Allow the combiham-
mer to cool down.
Printed: 30.04.2019 | Doc-Nr: PUB / 5351688 / 000 / 03