Operating Instruction TE 30-A36 (03)

6 English
=
Depth gauge
%
Function selector switch
&
Forward / reverse switch
(
Control switch
)
Battery state of charge / fault display
+
Release buttons / battery state of charge
display
§
Battery
/
Side handle
3.2 Intended use
The product described is a cordless (battery-powered) combihammer with pneumatic hammering mecha-
nism. It is designed for drilling in concrete, masonry, wood and metal. The product can also be used for light
to medium-duty chiseling on masonry and surface finishing work on concrete.
▶ Use only Hilti Li-ion batteries from the B 36 series with this product.
▶ Use only the Hilti battery chargers from the C4/36 series for these batteries.
3.3 Possible misuse
• This product is not suitable for working on hazardous materials.
• This product is not suitable for working in a damp environment.
3.4 ATC
The power tool is equipped with the ATC (Active Torque Control) quick-acting electronic cut-out.
If the accessory tool sticks or stalls, the power tool will suddenly pivot about its own axis in the opposite
direction. ATC detects this sudden pivoting movement of the power tool and switches the tool off immediately.
For ATC to function correctly, the power tool must be free to pivot.
After the power tool has cut out due to ATC, switch it back on again by releasing the control switch
for a moment and then pressing the switch again.
3.5 Motor protection system
The tool is equipped with a motor protection system. The system monitors current input and motor
temperature and thus prevents the tool from overheating.
If the motor is overloaded through application of excessive working pressure, the power tool’s performance
drops noticeably or it may stall completely.
If the power tool stalls or slows significantly due to overloading, release the pressure applied to the tool and
then allow it to run under no load for approx. 30 seconds.
3.6 Lithiumion battery status display
The Li-ion battery state of charge and malfunctions of the power tool are indicated by the display on the Liion
battery. The Liion battery state of charge is displayed after pressing one of the two battery release buttons.
Status Meaning
4 LEDs light. State of charge: 75 % to 100 %
3 LEDs light. State of charge: 50 % to 75 %
2 LEDs light. State of charge: 25 % to 50 %
1 LED lights. State of charge: 10 % to 25 %
1 LED blinks. State of charge: < 10 %
1 LED blinks, the power tool is not ready for use. The battery has overheated or is completely dis-
charged.
4 LEDs blink, the power tool is not ready for use. The power tool is overloaded or has overheated.
Battery state of charge cannot be displayed while the control switch is pressed and for up to 5 seconds
after releasing the control switch.
If the battery display LEDs blink, please observe the instructions given in the Troubleshooting section.
Printed: 30.04.2019 | Doc-Nr: PUB / 5351707 / 000 / 03