Manualshelf

Operating Instruction PM 30-MG (01)

ManualsBrandsHilti ManualsHand ToolsPM 30-MG 131 ft. Multi-Green Line Laser Level with Magnetic Bracket (Batteries not included)
11121314151617181920
Table Of Contents
***** Nur für internen Gebrauch ***** 07.02.2020 / 13:17:39 - H2\DOK-Sprachpaket\System\PM_30-G1\DEU\PM30-MG_POS1
14 English 2243556
*2243556*
3.2 Intended use
This tool is a self-leveling multi-line laser level that allows a single person to transfer right angles, level
horizontally, carry out alignment work and plumb accurately.
The product has three green 360° laser lines, a reference point directed downward on the right-hand front
of the measuring device, as well as four beam intersection points (front, back, left, right and above) with a
range of approx. 20 m. Range depends on the brightness of ambient light.
The product is designed for mainly indoor use and is no substitute for a rotating laser. For outdoor use make
sure that the boundary conditions are the same as for indoor use, or else use a Hilti laser receiver.
Possible applications are:
• Marking the position of partition walls (at right angles and in the vertical plane).
• Checking and transferring right angles.
• Aligning components to be installed or sections of a structure in three axes.
• Transferring points marked on the floor to the ceiling.
The laser lines can be switched on either separately (vertical or horizontal line only) or together. When used
with inclination angle, the pendulum for self-leveling is blocked.
▶ Use only Hilti LiIon batteries of the B 12 series with this product.
▶ Use only Hilti battery chargers of the C4/12 series for charging these batteries.
3.3 Features
The product is self-leveling to within typically approx. 4.0° in all directions. Self-leveling time is about 3
seconds.
When the self-leveling range is exceeded, the laser beams blink as a warning.
When switched on, the product defaults to visibility mode with high line brightness. Horizontal and vertical
lines can be switched on and off with the line mode button. To use the PMA 31G laser receiver, activate
receiver mode by pressing the receiver mode button.
3.4 Items supplied
Multi-line laser, magnetic holder, wall-mount holder, retaining strap, case, manufacturer's certificate.
Other system products approved for use with this product can be found at your local Hilti Store or online at:
www.hilti.group.
3.5 Information displayed during operation
Status Meaning
The laser beam blinks twice every 10 seconds
(pendulum not locked) or every 2 seconds (pen-
dulum locked).
The batteries are almost exhausted.
The laser beam blinks five times and then remains
permanently on.
Activation or deactivation of receiver mode.
The laser beam blinks very rapidly. The tool cannot level itself.
The laser beam blinks every 5 seconds. Inclined line operating mode; the pendulum is
locked, so the lines are not leveled.
4 Technical data
Range of the lines and intersection point with-
out laser receiver
20 m
(65 ft - 10 in)
Range, lines and intersection point with laser
receiver
2 m … 50 m
(6 ft - 10 in … 164 ft)
Self-leveling time (typical)
3 s
Self-leveling range
±4.0° (typical)
Accuracy
±3 mm at 10 m (±0.12 in at 33 ft)
Line width (distance 5 m - 16.4 ft)
< 2.2 mm (<0.09 in) typical
Laser class
Class 2, visible, 510530 nm