Use and Care Manual

9
Trouble or fault Possible cause Action to be taken
The rotary hammer or the
battery gets very hot.
Electrical fault. ▶ Switch off the rotary hammer
immediately. Remove the
battery and keep it under
observation. Allow it to cool
down. Contact Hilti service.
The rotary hammer has been over-
loaded.
▶ Use a more powerful tool.
The insert tool can’t be re-
leased.
The chuck is not pulled back fully. ▶ Pull the chuck back as far as it
will go and remove the tool.
The tool makes no progress. The rotary hammer has been set to
reverse rotation.
▶ Move the forward / reverse
selector switch to the “Forward”
position.
The function selector switch is set
to “Drilling without hammering” .
▶ Set the function selector switch
to “Hammer drilling” .
8 TE DRS-6-A dust removal module (optional)
The TE DRS6A dust removal module is an accessory for the Hilti TE 6A36 rotary hammer. It collects a
high percentage of the dust generated and can be quickly and easily attached to the rotary hammer. The
dust removal module is equipped with a suction fan. This fan is driven by its own motor. When the rotary
hammer is switched on the dust removal module draws its electric power from the rotary hammer’s battery.
The dust removal module is not suitable for working on metal and wood.
8.1 Overview of the product 13
@
Suction head
;
Stroke preselection button
=
DRS electrical interface
%
Release buttonDRS
&
Dust container release
(
Depth gauge
8.2 Technical data
Rated power input
60 W
Suction performance
66 liq. gal
US
/min
(250 ℓ/min)
Weight
2.2 lb
(1.0 kg)
8.3 Safety instructions
WARNING
Risk of injury Failure to follow safety instructions may lead to injury and / or damage to the equipment
or other property.
▶ Follow these safety instructions in order to avoid injury and / or damage to the equipment or other
property.
▶ Observe all safety instructions printed in this documentation and on the tool.
▶ Use respiratory protection to keep any remaining dust away from the face and airways when drilling and
when servicing the tool or accessories.
▶ Always use the side handle on the Hilti rotary hammer, even when the dust module is fitted.
8.4 Fitting the dust removal module 14
Note
Before fitting the module, check that the attachment points and the electrical interface on the rotary
hammer and dust removal module are free of dust and that the parts fit or move freely and easily.
1. Move the forward / reverse selector switch on the rotary hammer to the middle position.
Printed: 25.01.2016 | Doc-Nr: PUB / 5265030 / 000 / 00