Instructions / Assembly
Table Of Contents
- Original operating instructions
- 1 Information about the documentation
- 2 Safety
- 3 Description
- 4 Technical data
- 5 Operation
- 5.1 Inserting the battery
- 5.2 Fitting the belt hook (optional)
- 5.3 Fitting an accessory tool
- 5.4 Removing the accessory tool
- 5.5 Fitting an accessory tool
- 5.6 Removing the accessory tool
- 5.7 Setting the torque
- 5.8 Setting forward or reverse rotation
- 5.9 Screwdriving
- 5.10 Switching on
- 5.11 Switching off
- 5.12 Removing the battery
- 6 Care, maintenance, transport and storage
- 7 Troubleshooting
- 8 Disposal
- 9 Manufacturer’s warranty
12
1. Set the forward/reverse switch to the middle position or remove the battery from the power tool.
2. Pull the chuck ring forward and hold it in this position.
3. Pull the accessory tool out of the chuck.
4. Release the chuck ring.
5.5 Fitting an accessory tool
SIW 14A
SIW 22A
1. Check that the connection end of the accessory tool is clean.
Result
The connection end is dirty.
▶ Clean the connection end.
2. Set the forward/reverse switch to the middle position or remove the battery from the power tool.
3. Bring the notch in the accessory tool into alignment with the ball on the square drive.
4. Push the accessory tool onto the square drive until it engages.
5.6 Removing the accessory tool
SIW 14A
SIW 22A
CAUTION
Risk of injury. The accessory tool may be hot or have sharp edges.
▶ Wear protective gloves when using the power tool and when changing accessory tools.
Printed: 27.07.2016 | Doc-Nr: PUB / 5293001 / 000 / 00