Use and Care Manual

***** For internal use only ***** 27.07.2016 / 10:05:37 - H2\DOK-Projekt\System\WSR_22-A-G1\ENU\WSR18-A_P3
15
6.2 Transport and storage of cordless tools
Transport
CAUTION
Inadvertent starting during transport. Uncontrolled starting during transport may occur if the battery
is fitted, thereby resulting in damage to the tool.
▶ Always remove the battery before transporting the tool.
▶ Remove the battery.
▶ Transport the tool and batteries individually packaged.
▶ Never transport batteries in bulk form (loose, unprotected).
▶ Check the tool and batteries for damage before use after long periods of transport.
Storage
CAUTION
Inadvertent damage caused by defective battery. A leaking battery may damage the tool.
▶ Always remove the battery before storing the tool.
▶ Store the tool and batteries in a place that is as cool and dry as possible.
▶ Never store batteries in direct sunlight, on heating units or behind a window pane.
▶ Store the tool and batteries in a place where they cannot be accessed by children or unauthorized
persons.
▶ Check the tool and batteries for damage before use after long periods of storage.
6.3 Checks after care and maintenance work
▶ After carrying out care and maintenance, check that all protective and safety devices are fitted and that
they function faultlessly.
7 Troubleshooting
▶ If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
7.1 The reciprocating saw is not operational.
Malfunction Possible cause Action to be taken
The LEDs indicate nothing. The battery is not fully inserted. ▶ Push the battery in until it
engages with a double click.
The battery is empty. ▶ Charge the battery.
The transport lock is engaged. ▶ Disengage the transport lock.
1 LED blinks. The battery is discharged. ▶ Change the battery and charge
the empty battery.
The battery is too hot or too cold. ▶ Bring the battery to the recom-
mended working temperature.
7.2 The reciprocating saw is operational.
Trouble or fault Possible cause Action to be taken
The tool does not achieve full
power.
The control switch is not fully
pressed.
▶ Press the control switch fully.
The battery is discharged. ▶ Change the battery and charge
the empty battery.
The saw blade can’t be re-
moved from the chuck.
The locking sleeve is not turned as
far as it will go.
▶ Turn the locking sleeve as far as
it will go and remove the saw
blade.
Printed: 27.07.2016 | Doc-Nr: PUB / 5293015 / 000 / 00