Operating Instruction AG 500-11S (05)

14 English 2141935
*2141935*
AG 500-11S
Weight
5.5 lb
(2.5 kg)
Drive spindle thread
5/8"-11
6 Before use
CAUTION
Risk of injury. The accessory tool may be hot or have sharp edges.
▶ Wear protective gloves when fitting, removing or adjusting the accessory
tool or other parts and when troubleshooting.
6.1 Fitting the side handle
▶ Screw the side handle into one of the threaded bushings provided.
6.2 Guard
▶ Observe the instructions for fitting the applicable guard.
6.2.1 Installing the guard 6
The guard is keyed to ensure that only guards of a type suitable for use
with the product can be installed. The keyed locating lug also prevents
the guard from coming into contact with the tool.
1. Fit the guard on to the arbor collar so that the two triangular marks on the
guard and on the product are in alignment.
2. Press the guard on to the drive spindle collar.
3. Press the guard release button and turn the guard until it engages in the
desired position.
➥ The guard release button jumps back.
6.2.2 Adjusting the guard 7
▶ Press the guard release button and then rotate the guard until it engages
in the desired position.
6.2.3 Removing the guard
1. Press the guard release button and turn the guard until the triangular
marks on the guard and on the product are in alignment.
2. Lift off the guard.
6.3 Fitting or removing the front cover 8
1. Position the front cover with the closed side on the standard guard and
push it on until it engages.
2. To remove it, release the catch for the front cover and then lift the front
cover away from the standard guard.
Printed: 19.10.2018 | Doc-Nr: PUB / 5402266 / 000 / 01