OSHA 1926.1153, Section XII

ManualsBrandsHilti ManualsGrinders & SandersAG 500-11S Angle grinder

HILTI SUBMITTAL PACKAGE

OSHA 1926.1153 TABLE 1,

SECTION xii

Sections xii: Handheld grinders

for uses other than mortar removal

Current Hilti angle grinders with a Hilti grinding hood:

AG 450-7S

AG 450-7D

DEG 500

DAG 500-D

DCG 500-S

AG 500-11S

AG 500-12D

DG 150

DBS • 08/17

For instructions on how to assemble

these systems, please refer to the

Hilti North America Youtube page

DG 150

Angle grinders with a grinding hood

Summary of content (8 pages)

PAGE 1
HILTI SUBMITTAL PACKAGE OSHA 1926.
PAGE 2
TABLE 1 REQUIREMENTS These systems fall under table 1, section xii: handheld grinders for use other than mortar removal.
PAGE 3
AG Grinding Submittal Check below to see how your system can be compliant with 1926.1153 Table 1. To verify the generation of your tool, check the rating plate, or call Hilti at 800-879-8000 with your serial number.
PAGE 4
SYSTEM OVERVIEW Hilti concrete grinding tools are table 1 compliant through use of a dust collection shroud hooked up to a vacuum that meets table 1 requirements.
PAGE 5
AG Grinding Submittal Tool Accessory Vacuum (use any) VC 125-6 VC 125-9 VC 150-6 XE VC 150-6 X VC 150-10 X VC 150-10 XE AG 600-A 36 grinding hoods for AG 600 are designed for 5 inch max. diameter wheels only 5” grinding hood VC 300-17 X DG 150 Vacuum adapter *Exposure assessment required **See Hilti’s published Objective Data — if not applicable to a specific application, exposure assessment is required.
PAGE 6
PAGE 7
AG Grinding Submittal 7
PAGE 8
GRINDING Grinding Dust Control — OSHA Hilti developed dust collection systems for its angle grinders with a shroud, to be attached to a Hilti vacuum with a filter cleaning mechanism and 99% filter efficiency, compliant with OSHA 1926.1153, Table 1. Set-up 1. Attach the appropriate dust collection shroud to the grinder. 2. S elect appropriately‐sized vacuum (per OSHA Table 1, the vacuum must have a rating of at least 25 cfm per inch of wheel diameter). Attach vacuum hose to grinder shroud. 3.