Instructions / Assembly

8 English
5.7 Setting the laser beams to the “Inclined line” function
1.
Turn the rotary switch to the position (on/locked).
◁ Only the horizontal laser beam is then visible.
2. Press the line mode selector button repeatedly until the desired line mode is set.
Note
When the “Inclined line” function is active, the pendulum is locked and the tool is not leveled.
The laser beam(s) blink every 5 seconds.
The operating modes change in the following sequence and the sequence then repeats itself:
Horizontal laser line, vertical laser line, vertical and horizontal laser lines.
5.8 Examples of applications
Note
The adjustable feet allow the tool to be pre-leveled approximately on very uneven surfaces.
5.8.1 Transferring heights
5.8.2 Setting up drywall track for a partition wall
Printed: 07.09.2017 | Doc-Nr: PUB / 5343678 / 000 / 02