Instructions / Assembly

English 5
@
Adjustable foot
;
Liion battery
=
Warning sticker
%
Selector button for line and receiver mode
&
Laser exit window
(
Rotary on/off and pendulum lock switch
)
Fine adjustment for rotation platform
+
Circular bubble level
3.2 Intended use
This tool is a self-leveling multi-line laser level that allows a single person to transfer right angles, level
horizontally, carry out alignment work and plumb accurately.
The tool has three green laser lines (one horizontal and two vertical), a reference point below the tool as well
as four beam intersection points (front, back, left, right and above) with a range of approx. 20 m. Range
depends on the brightness of ambient light.
The tool is designed for mainly indoor use and is no substitute for a rotating laser level. If used for outdoor
applications, care must be taken to ensure that the conditions are the same as for indoor applications. If this
is not the case, the Hilti PMA 31G laser receiver should be used.
Possible applications are:
• Marking the position of partition walls (at right angles and in the vertical plane).
• Checking and transferring right angles.
• Aligning components to be installed or sections of a structure in three axes.
• Transferring points marked on the floor to the ceiling.
The laser lines can be switched on either separately (vertical or horizontal line only) or together. When used
with inclination angle, the pendulum for automatic leveling is blocked.
▶ Use only Hilti B12 2.6 Li-ion batteries with this tool.
▶ Use only the Hilti C4/12-50 charger to charge these batteries.
3.3 Features
The tool levels itself automatically within a range of approx. 3.0°. If this is not sufficient, the tool can be
leveled using the adjustable feet and circular bubble level. Self-leveling takes only about 3 seconds.
When the self-leveling range is exceeded, the laser beams blink as a warning.
When switched on initially, the tool is in standard mode, i.e. visible beam mode with high line brightness.
When the selector button for line and receiver mode is pressed and held for a short time the tool switches to
receiver mode and is then compatible with the PMA 31G laser receiver. Receiver mode can be deactivated
by again pressing and holding the selector button for a short time or by switching the tool off.
3.4 Items supplied
Multi-line laser, toolbox, operating instructions, manufacturer’s certificate.
You can find other system products approved for your product at your local Hilti Center or online at:
www.hilti.com
3.5 Information displayed during operation
Status Meaning
The laser beam blinks twice every 10 seconds
(pendulum not locked) or every 2 seconds (pen-
dulum locked).
• The batteries are almost exhausted.
The laser beam blinks five times and then remains
permanently on.
• Activation or deactivation of receiver mode.
The laser beam blinks very rapidly. • The tool cannot level itself.
The laser beam blinks every 5 seconds. • Inclined line operating mode; the pendulum is
locked, so the lines are not leveled.
4 Technical data
Range of the lines and intersection
point without laser receiver
20 m
Range, lines and intersection point
with laser receiver
2 m …50 m
Printed: 07.09.2017 | Doc-Nr: PUB / 5343678 / 000 / 02