Instructions / Assembly

English 7

5.2 Removing / adjusting the base plate

1. Remove the base plate by pulling it forward and clear of the device.

2. The rubber sleeves of the feet can be pulled down to provide protection if the device has to be set up on

an easily damaged surface.

3. The feet of the base plate can be screwed out for leveling.

5.3 Switching the laser beams on

Turn the rotary switch to the position (on/unlocked).

◁ The vertical laser beams are visible.

2. Press the mode selector button repeatedly until the desired line mode is set.

Note

The operating modes change in the following sequence and the sequence then repeats itself:

Vertical laser lines, horizontal laser line, vertical and horizontal laser lines.

5.4 Switching the laser beams off

▶ Turn the rotary switch to the OFF position (off/locked).

◁ The laser beam is no longer visible and the pendulum is locked.

Note

The tool switches itself off when the battery is low.

5.5 Activating or deactivating laser receiver mode

1. To activate receiver mode, press the line / receiver mode selector button for longer than 4 seconds until

the laser beam blinks 5 times as confirmation.

2. To deactivate receiver mode, press the selector button again for longer than 4 seconds.

Note

Receiver mode is deactivated when the tool is switched off.

5.6 Setting the laser beams to the “Inclined line” function

Turn the rotary switch to the position (on/locked).

◁ Only the horizontal laser beam is then visible.

2. Press the line mode selector button repeatedly until the desired line mode is set.

Note

When the “Inclined line” function is active, the pendulum is locked and the tool is not leveled.

The laser beam(s) blink every 5 seconds.

The operating modes change in the following sequence and the sequence then repeats itself:

Horizontal laser line, vertical laser line, vertical and horizontal laser lines.

Printed: 07.09.2017 | Doc-Nr: PUB / 5343678 / 000 / 02