Manualshelf

Use and Care Manual

ManualsBrandsHilti ManualsDrills120-Volt 13 Amp Corded 1-9/16 in. SDS-Max TE 60-AVR Rotary Hammer, Dust Removal System Kit, Cord and TE-YX Drill Bit
11121314151617181920
English 15
5.1.4 Fitting the accessory tool
1. Apply a little grease to the connection end of the accessory tool.
◁ Use only the recommended grease supplied by Hilti. Using the wrong
grease can result in damage to the tool.
2. Push the accessory tool into the chuck as far as it will go (until it engages).
3. After fitting the accessory tool, grip it and pull it in order to check that it is
securely engaged.
◁ The product is ready for use.
5.1.5 Removing the accessory tool
CAUTION
Risk of injury! The accessory tool gets hot during use.
▶ Wear protective gloves when changing the accessory tool.
▶ Do not place the hot accessory tool on readily flammable materials.
▶ Pull the chuck back as far as it will go and remove the accessory tool.
Printed: 28.06.2017 | Doc-Nr: PUB / 5277966 / 000 / 01