Use and Care Manual

*2204401*
2204401 English 9
3.2 Intended use
The product described is an electrically powered diamond core drilling machine. It is designed for hand-
guided wet and dry drilling, for wet drilling with a drilling rig as through-holes and I or blind holes in (reinforced)
mineral substrates.
• The tool may be operated only when connected to a power source providing a voltage and frequency in
compliance with the information given on the type identification plate.
3.3 Bluetooth
®
This product has Bluetooth.
Bluetooth is a wireless data transfer system by which the two Bluetooth-enabled products can communicate
with each other over a short distance.
To ensure a stable Bluetooth connection there must be a clear line of sight between the connected devices.
Bluetooth functions of this product
Consult the operating instructions of the paired device for detailed descriptions of the Bluetooth functions.
• Service and status messages of the paired Hilti devices are shown on the display of the diamond core
drilling machine.
• Connection with a mobile terminal device via the Hilti Connect app for service functions and for
transmission of product-related analysis data.
Switching Bluetooth on/off
Hilti products are delivered with Bluetooth turned off. On first start up, Bluetooth is switched on
automatically.
•
To switch off, press and hold down the buttons and simultaneously for at least 10 seconds.
•
To switch on, press the buttons and simultaneously.
Connecting products
The pairing with a Bluetooth-compatible Hilti device is sustained until the diamond core drilling machine is
paired to another Hilti device of the same type or Bluetooth is switched off. Pairing is also sustained even
when the products are switched off and then on again; paired products always automatically re-establish
their paired connection.
• To pair with a Bluetooth-compatible Hilti device or mobile device, with Bluetooth switched on simulta-
neously press the and buttons.
The time window for pairing with a Bluetooth-compatible Hilti device is 2 minutes. When the 2 minutes
have expired, the pairing process is canceled.
License
The Bluetooth
®
word mark and the logo are registered trademarks and the property of Bluetooth SIG, Inc.
and Hilti has been granted a license to use these trademarks.
3.4 Display symbols and explanation of the multifunction display on the diamond core drilling
machine
For the following information to be displayed, the diamond core drilling machine must be ready for operation
(plugged in and PRCD switched on).
The displays may vary depending on the gear selection and the type of application.
Starting screen
The start screen is displayed when the diamond core drilling machine is
supplied with power. The Bluetooth status, the personalized name and the
serial number of the diamond core drilling machine are shown on the start
screen.
• You can change the product name that appears on the screen in the
Hilti Connect app (default: 'Your name here').
Spirit level
The diamond core drilling machine is not switched on. The display helps
you to level the system and to align the drill stand when drilling at an angle.
The display shows the alignment of the diamond core drilling machine
symbolically and in degrees.
• Angular accuracy at room temperature: ±2°