User's Manual

6
Status Meaning
«+» • Standard fastener driving depth
«» • Reduced fastener driving depth
«EJECT» • Fastener guide release
3.7 Support leg
On an even working surface, the support leg makes it easier to hold the fastening tool
perpendicular as attention then only has to be paid to lateral alignment. On an uneven or
undulating surface it may be necessary to remove the support leg in order to allow the
fastener guide to be held perpendicular to the working surface.
3.8 Belt hook
The belt hook can be extended in three stages.
Status Meaning
Position 1 • Position for attaching to a waist belt
Position 2 • Position for attaching to ladders,
scaffolds, platforms, etc.
Position 3 • Belt hook removed
3.9 Gas can
Note
Observe the safety instructions provided with the gas can!
In order to operate the fastening tool, the gas can must be inserted in the gas can
compartment.
The gas can status can be read from the LED display after pressing the ‚GAS‘ button.
The gas can must be removed before breaks between working, before maintenance and
before transporting or storing the fastening tool.
3.10 Indication of gas can status
After pressing the ‚GAS‘ button, the LED display indicates the status of the gas can.
Status Meaning
All four LEDs light green. • The level is between 100 % and 75 %.
Three LEDs light green. • The level is between 75 % and 50 %.
Two LEDs light green. • The level is between 50 % and 25 %.
One LED lights green. • The level is between 25 % and 10 %.
One LED blinks green. • Level is below 10 %. Replacement of
the gas can is recommended.
One LED blinks green. • The gas can is empty or is malfunc-
tioning. Replacement of the gas can is
recommended.
Note
Even when the level is indicated as
“empty”, the gas can, for technical
reasons, still contains a little gas.