User's Manual
>1/4s
35
+LOWL WUDGHPDUNRIWKH+LOWL&RUSRUDWLRQ6FKDDQ/,
0DGHLQ*HUPDQ\
1PXFS
7OPN
N"
/$6(55$',$7,21'2127
67$5(,172%($0
QPP:PD[
&/$66,,/$6(5352'8&7
$"65*0/
(1
1. General information
1.1 Safety notices and their meaning
DANGER
Draws attention to imminent danger that could lead
to serious bodily injury or fatality.
WARNING
Draws attention to a potentially dangerous situation
that could lead to serious personal injury or fatality.
CAUTION
Draws attention to a potentially dangerous situation
that could lead to slight personal injury or damage to
the equipment or other property.
NOTE
Draws attention to an instruction or other useful
information.
1.2 Explanation of the pictograms and other
information
Symbols
Read the
operating
instructions
before use.
General
warning
Return waste
material for
recycling.
Do not look
into the beam.
Symbol for Laser Class II / Class 2
Laser class II according
to CFR 21, § 1040 (FDA)
Laser class 2
according to
EN 60825:2008
Type identification plate
PR 35
Location of identification data on the tool
The type designation and serial number can be found
on the type identification plate on the tool. Make a
note of this data in your operating instructions and
always refer to it when making an enquiry to your
Hilti representative or service department.
Type:
Generation: 01
Serial no.:
2. Description
2.1 Use of the product as directed
The tool is designed to be used to determine, transfer and check levels, verticals, slopes and right angles.
Examples of its uses are: transferring datums and height marks, determining right angles for walls, vertical
alignment on reference points and setting out slopes.
Use of tools or AC adapters which show visible signs of damage is not permissible. Operation outdoors or in
damp conditions in “Charging during operation mode” is not permissible.
To avoid the risk of injury, use only genuine Hilti accessories and insert tools.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
en
2