ICC-ES ESR-4878 for HIT-HY 200 V3

ICC-ES Evaluation Reports are not to be construed as representing aesthetics or any other attributes not specifically addressed, nor are they to be construed
as an endorsement of the subject of the report or a recommendation for its use. There is no warranty by ICC Evaluation Service, LLC, express or implied, as
to any finding or other matter in this report, or as to any product covered by the report.
Copyright © 2021 ICC Evaluation Service, LLC. All rights reserved. Page 14 of 15
ICC-ES Evaluation Report
ESR-4878 LABC and LARC Supplement
Issued November 2021
This report is subject to renewal November 2022.
www.icc-es.org | [phone] | [phone] A Subsidiary of the International Code Council
®
DIVISION: 04 00 00—MASONRY
Section: 04 05 19.16—Masonry Anchors
REPORT HOLDER:
HILTI, INC.
EVALUATION SUBJECT:
HILTI HIT-HY 200 V3 ADHESIVE ANCHOR SYSTEM
1.0 REPORT PURPOSE AND SCOPE
Purpose:
The purpose of this evaluation report supplement is to indicate that the Hitli HIT-HY 200 V3 Adhesive Anchor System,
described in ICC-ES evaluation report ESR-4878, has also been evaluated for compliance with the codes noted below as
adopted by the Los Angeles Department of Building and Safety (LADBS).
Applicable code editions:
 2020 City of Los Angeles Building Code (LABC)
 2020 City of Los Angeles Residential Code (LARC)
2.0 CONCLUSIONS
The Hitli HIT-HY 200 V3 Adhesive Anchor System, described in Sections 2.0 through 7.0 of the evaluation report
ESR-4878, complies with LABC Chapter 21, and LARC, and is subject to the conditions of use described in this supplement.
3.0 CONDITIONS OF USE
The Hitli HIT-HY 200 V3 Adhesive Anchor System described in this evaluation report supplement must comply with all of the
following conditions:
 All applicable sections in the evaluation report ESR-4878.
 The design, installation, conditions of use and labeling of the Hitli HIT-HY 200 V3 Adhesive Anchor System are in
accordance with the 2018 International Building Code
®
(2018 IBC) provisions noted in the evaluation report ESR-4878.
 The design, installation and inspection are in accordance with additional requirements of LABC Chapters 16 and 17, as
applicable.
 Under the LARC, an engineered design in accordance with LARC Section R301.1.3 must be submitted.
 The allowable design values listed in the evaluation report and tables are for the connection of the adhesive anchors to
fully grouted concrete masonry walls. The connection between the adhesive anchors and the connected members shall
be checked for capacity (which may govern).
 For use in wall anchorage assemblies to flexible diaphragm applications, anchors shall be designed per the requirements
of City of Los Angeles Information Bulletin P/BC 2017-071.
This supplement expires concurrently with the evaluation report, issued November 2021.