ICC ESR-2795 for Wire Hanger System X-MW

ICC-ES Evaluation Reports are not to be construed as representing aesthetics or any other attributes not specifically addressed, nor are they to be construed
as an endorsement of the subject of the report or a recommendation for its use. There is no warranty by ICC Evaluation Service, LLC, express or implied, as
to any finding or other matter in this report, or as to any product covered by the report.
Copyright © 2021 ICC Evaluation Service, LLC. All rights reserved. Page 10 of 11
ICC-ES Evaluation Report
ESR-2795 LABC and LARC Supplement
Reissued June 2021
Revised August 2021
This report is subject to renewal June 2023.
www.icc-es.org | [phone] | [phone] A Subsidiary of the International Code Council
®
DIVISION: 03 00 00—CONCRETE
Section: 03 16 00—Concrete Anchors
DIVISION: 05 00 00—METALS
Section: 05 05 23—Metal Fastenings
REPORT HOLDER:
HILTI, INC.
EVALUATION SUBJECT:
HILTI LOW-VELOCITY POWER-ACTUATED X-DR, X-DR MX AND X-HS ROD HANGER ASSEMBLIES AND X-MW ALH
AND X-MW MX WIRE HANGER ASSEMBLIES
1.0 REPORT PURPOSE AND SCOPE
Purpose:
The purpose of this evaluation report supplement is to indicate that the Hilti Low-Velocity Power-Actuated X-DR, X-DR MX
and X-HS Rod Hanger Assemblies and X-MW and X-MW MX Wire Hanger Assemblies, described in ICC-ES evaluation report
ESR-2795, have also been evaluated for compliance with the codes noted below as adopted by the Los Angeles Department
of Building and Safety (LADBS).
Applicable code editions:
 2020 City of Los Angeles Building Code (LABC)
 2020 City of Los Angeles Residential Code (LARC)
2.0 CONCLUSIONS
The Hilti Low-Velocity Power-Actuated X-DR, X-DR MX and X-HS Rod Hanger Assemblies and X-MW and X-MW MX Wire
Hanger Assemblies, described in Sections 2.0 through 7.0 of evaluation report ESR-2795, comply with LABC Chapters 19 and
22, and the LARC, and are subject to the conditions of use described in this supplement.
3.0 CONDITIONS OF USE
The Hilti Low-Velocity Power-Actuated X-DR, X-DR MX and X-HS Rod Hanger Assemblies and X-MW and X-MW MX Wire
Hanger Assemblies described in this evaluation report supplement must comply with all of the following conditions:
• All applicable sections in the evaluation report ESR-2795.
• The design, installation, conditions of use and identification are in accordance with the 2018 International Building Code
®
(2018 IBC) provisions noted in the evaluation report ESR-2795.
• The design, installation and inspection are in accordance with additional requirements of LABC Chapters 16 and 17, as
applicable.
• Under the LARC, an engineered design in accordance with LARC Section R301.1.3 must be submitted.
• The allowable values listed in the evaluation report and tables are for the rod hanger assembly or wire hanger assembly
only. Connected members shall be checked for their capacity (which may govern).
This supplement expires concurrently with the evaluation report, reissued June 2021, and revised August 2021.