ICC ESR-2795 for Wire Hanger System X-MW

ICC-ES Evaluation Reports are not to be construed as representing aesthetics or any other attributes not specifically addressed, nor are they to be construed
as an endorsement of the subject of the report or a recommendation for its use. There is no warranty by ICC Evaluation Service, LLC, express or implied, as
to any finding or other matter in this report, or as to any product covered by the report.
Copyright © 2021 ICC Evaluation Service, LLC. All rights reserved. Page 11 of 11
ICC-ES Evaluation Report
ESR-2795 FBC and FRC Supplement
Reissued June 2021
Revised August 2021
This report is subject to renewal June 2023.
www.icc-es.org | [phone] | [phone] A Subsidiary of the International Code Council
®
DIVISION: 03 00 00—CONCRETE
Section: 03 16 00—Concrete Anchors
DIVISION: 05 00 00—METALS
Section: 05 05 23—Metal Fastenings
REPORT HOLDER:
HILTI, INC.
EVALUATION SUBJECT:
HILTI LOW-VELOCITY POWER-ACTUATED X-DR, X-DR MX AND X-HS ROD HANGER ASSEMBLIES AND X-MW ALH
AND X-MW MX WIRE HANGER ASSEMBLIES
1.0 REPORT PURPOSE AND SCOPE
Purpose:
The purpose of this evaluation report supplement is to indicate that the Hilti Low-Velocity Power-Actuated X-DR, X-DR MX
and X-HS Rod Hanger Assemblies and X-MW and X-MW MX Wire Hanger Assemblies, addressed in ICC-ES evaluation
report ESR-2795, have also been evaluated for compliance with the codes noted below.
Applicable code editions:
 2020 Florida Building Code—Building
 2020 Florida Building Code—Residential
Property evaluated:
Structural
2.0 CONCLUSIONS
The Hilti Low-Velocity Power-Actuated X-DR, X-DR MX and X-HS Rod Hanger Assemblies and X-MW and X-MW MX Wire
Hanger Assemblies, described in Sections 2.0 through 7.0 of evaluation report ESR-2795, comply with the Florida Building
Code—Building and the Florida Building Code—Residential. The design requirements must be determined in accordance
with the Florida Building Code—Building or the Florida Building Code—Residential, as applicable. The installation
requirements noted in ICC-ES evaluation report ESR-2795 for the 2018 International Building Code
®
meet the requirements
of the Florida Building Code—Building or the Florida Building Code—Residential, as applicable.
Use of the Hilti rod hanger assemblies and wire hanger assemblies has also been found to be in compliance with the High-
Velocity Hurricane Zone provisions of the Florida Building Code—Building and the Florida Building Code—Residential under
the following conditions:
• The assemblies have not been evaluated for use as cast-in-place anchors for compliance with the High-Velocity
Hurricane Zone provisions, and this use is outside the scope of this evaluation report.
For products falling under Florida Rule 61G20-3, verification that the report holder’s quality assurance program is audited
by a quality assurance entity approved by the Florida Building Commission for the type of inspections being conducted is the
responsibility of an approved validation entity (or the code official when the report holder does not possess an approval by
the Commission).
This supplement expires concurrently with the evaluation report, reissued June 2021 and revised August 2021.