Operating Instruction DX 351 (01)

29
en
Fault
Cause Possible remedies
■ The piston is damaged
■ Remains of plastic strip in maga-
zine
■ Driving power too high when dri-
ving into steel
■ Firing the tool with high power
without a fastener in place
■ The tool is dirty (carbon build-
up)
■ Unscrew the magazine
■ Unscrew the black housing
■ Check the piston and replace if
necessary (see 7.1–7.5)
■ Open the magazine and remove
the nail strip and any plastic
remains
■ Reduce driving power
■ Avoid firing without a fastener in
place
■ Clean the tool (see 8.1–8.8)
Nail jams in the magazine
■ 2 nails are jammed together in
the magazine
■ Insert the tip of a screwdriver
through the furthest forward slot
in the magazine and push the
nails out
Piston guide sticks