Operating Instruction TE 2, TE 2-S, TE 2-M (02)
Table Of Contents
- Original operating instructions
- 1 Information about the documentation
- 2 Safety
- 3 Description
- 4 Technical data
- 5 Operation
- 5.1 Fitting the side handle
- 5.2 Fitting / removing the chuck
- 5.3 Fitting/removing the drill bit or other accessory: SDS chuck
- 5.4 Fitting/removing the drill bit or other accessory: Quick-release chuck
- 5.5 Adjusting the depth gauge
- 5.6 Drilling with hammering action (hammer drilling)
- 5.7 Light hammering action
- 5.8 Drilling
- 5.9 Drilling in first gear or drilling in second gear
- 5.10 Forward / reverse
- 6 Care and maintenance
- 7 Transport and storage
- 8 Troubleshooting
- 9 Disposal
- 10 Manufacturer’s warranty
English 9
5 Operation
5.1 Fitting the side handle
CAUTION
Risk of injury! The depth gauge, if fitted but not used, might hinder the operator.
▶ Remove the depth gauge from the tool.
CAUTION
Risk of injury! Loss of control over the rotary hammer drill.
▶ Check that the side handle is fitted correctly and tightened securely. Check that the clamping
band is engaged in the groove in the tool.
▶ Fit the side handle.
5.2 Fitting / removing the chuck
TE 2-M
▶ Fit / remove the chuck.
5.3 Fitting/removing the drill bit or other accessory: SDS chuck
Note
Use of unsuitable grease may cause damage to the product. Use only the recommended grease
supplied by Hilti.
Printed: 04.10.2017 | Doc-Nr: PUB / 5261122 / 000 / 01