Operating Instruction TE 2, TE 2-S, TE 2-M (02)
Table Of Contents
- Original operating instructions
- 1 Information about the documentation
- 2 Safety
- 3 Description
- 4 Technical data
- 5 Operation
- 5.1 Fitting the side handle
- 5.2 Fitting / removing the chuck
- 5.3 Fitting/removing the drill bit or other accessory: SDS chuck
- 5.4 Fitting/removing the drill bit or other accessory: Quick-release chuck
- 5.5 Adjusting the depth gauge
- 5.6 Drilling with hammering action (hammer drilling)
- 5.7 Light hammering action
- 5.8 Drilling
- 5.9 Drilling in first gear or drilling in second gear
- 5.10 Forward / reverse
- 6 Care and maintenance
- 7 Transport and storage
- 8 Troubleshooting
- 9 Disposal
- 10 Manufacturer’s warranty
12 English
5.8 Drilling
TE 2
TE 2-S
▶
Set the function selector switch to the “Drilling” position.
5.9 Drilling in first gear or drilling in second gear
TE 2-M
▶ Set the function selector switch to the “Drilling in first gear” or “Drilling in second gear” position.
5.10 Forward / reverse
Risk of damage Actuation while the tool is running may result in damage to the gearing.
▶ Do not operate the forward / reverse switch while the motor is running.
Printed: 04.10.2017 | Doc-Nr: PUB / 5261122 / 000 / 01