Operating Instruction TE 2, TE 2-S, TE 2-M (02)
Table Of Contents
- Original operating instructions
- 1 Information about the documentation
- 2 Safety
- 3 Description
- 4 Technical data
- 5 Operation
- 5.1 Fitting the side handle
- 5.2 Fitting / removing the chuck
- 5.3 Fitting/removing the drill bit or other accessory: SDS chuck
- 5.4 Fitting/removing the drill bit or other accessory: Quick-release chuck
- 5.5 Adjusting the depth gauge
- 5.6 Drilling with hammering action (hammer drilling)
- 5.7 Light hammering action
- 5.8 Drilling
- 5.9 Drilling in first gear or drilling in second gear
- 5.10 Forward / reverse
- 6 Care and maintenance
- 7 Transport and storage
- 8 Troubleshooting
- 9 Disposal
- 10 Manufacturer’s warranty
English 13
▶ Set the forward / reverse selector switch to forward or reverse rotation.
6 Care and maintenance
WARNING
Danger of electric shock! Carrying out care and maintenance while the supply cord is connected to
the power outlet presents a risk of serious injuries including burns.
▶ Always unplug the supply cord before carrying out all care and maintenance tasks.
Care
• Carefully remove stubborn dirt from the tool.
• Clean the air vents carefully with a dry brush.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
they can attack the plastic parts.
Maintenance
WARNING
Danger of electric shock! Improper repairs to electrical components may lead to serious injuries
including burns.
▶ Repairs to the electrical section of the tool or appliance may be carried out only by trained electrical
specialists.
• At regular intervals, check all visible parts and the controls for signs of damage and make sure that they
all function correctly.
• Do not operate the power tool if signs of damage are found or if parts malfunction. Have damage repaired
immediately by Hilti Service.
• After cleaning and maintenance, refit all guards or protective devices and check that they function
correctly.
Printed: 04.10.2017 | Doc-Nr: PUB / 5261122 / 000 / 01