Operating Instruction SSF BT-22A (01)

English 5
Status Meaning
1 LED blinks, the power tool is not ready for use. • The battery has overheated or is completely
discharged.
4 LEDs blink, the power tool is not ready for use. • The power tool is overloaded or has overheated.
Note
Battery charge status cannot be displayed while the control switch is pressed and for up to 5 seconds
after releasing the control switch.
If the battery display LEDs blink, please observe the instructions given in the Troubleshooting section.
3.6 Items supplied
Electric drill, operating instructions.
Note
You can find other system products approved for your product at your local Hilti Center or online at:
www.hilti.com.
4 Technical data
Rated voltage
21.6 V
Weight
4.2 lb
(1.9 kg)
Torque
≤ 7 ftlb
f
(≤ 9 Nm)
Keyless chuck clamping range
3/64 in … 25/64 in
5 Operation
5.1 Inserting the battery 3
CAUTION
Risk of injury. The drill may start inadvertently.
▶ Before fitting the battery, check that the drill is switched off and that the switch safety lock is
activated.
CAUTION
Electrical hazard. Dirty contacts may cause a short circuit.
▶ Before inserting the battery, check to ensure that the battery terminals and the contacts on the
drill are free from foreign objects.
CAUTION
Risk of injury. If the battery is not fitted correctly it may drop out and fall.
▶ Check that the battery is securely seated in the drill so that it cannot drop out and fall, thereby
presenting a hazard to other persons.
▶ Push the battery into the drill from the rear until it is heard to engage with a click.
5.2 Removing the battery 4
▶ Remove the battery.
Printed: 19.10.2016 | Doc-Nr: PUB / 5310861 / 000 / 00