SD 2500 SD 4500 Printed: 22.10.
Printed: 22.10.
1 Information about the documentation 1.1 • • • About this documentation Read this documentation before initial operation or use. This is a prerequisite for safe, trouble-free handling and use of the product. Observe the safety instructions and warnings in this documentation and on the product. Always keep the operating instructions with the product and make sure that the operating instructions are with the product when it is given to other persons. 1.2 Explanation of symbols used 1.2.
1.3 Product information Hilti products are designed for professional use and may be operated, serviced and maintained only by trained, authorized personnel. This personnel must be informed of any particular hazards that may be encountered. The product and its ancillary equipment may present hazards when used incorrectly by untrained personnel or when used not as directed. • Make a note of the designation and serial number printed on the identification plate in the following table.
Personal safety ▶ Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication. A moment of inattention while operating power tools may result in serious personal injury. ▶ Use personal protective equipment. Always wear eye protection.
▶ ▶ ▶ ▶ ▶ ▶ ▶ ▶ Wear suitable protective glasses, a hard hat, ear protection, protective gloves and light respiratory protection while using the tool. Always activate the safety lock before changing accessory tools, before storing the electric tool or before transporting it. Wear protective gloves also when changing the accessory tool. Touching the accessory tool presents a risk of injury (cuts or burns). Wear eye protection. Flying fragments present a risk of injury to the body and eyes.
3 Description 3.1 Overview of the product English Printed: 22.10.
Bit holder Chuck Power tool / accessory interface (snap-on connection) Coupling system / gearing Belt hook Motor Air intake @ ; = % & ( ) 3.2 + § / : ∙ $ £ Forward/reverse switch Lockbutton for continuous operation On / off switch Supply cord Type identification plate Air exit Depth gauge Intended use The product described is a hand-held mains-powered electric tool for use in drywall installation. The power tool is designed for driving and removing screws in drywall installation work.
▶ Set the forward / reverse selector switch to forward or reverse rotation. 5.2 Changing the accessory tool. 1. Pull the depth gauge away from the power tool, releasing the snap-on connection. 2. Push the chuck towards the screwdriver, turning the chuck slightly at the same time, and then hold it in this position. 3. Remove the accessory tool with your other hand. 4. Insert the desired accessory tool in the chuck, pushing it into the screwdriver as far as it will go. 5.
3. Insert the bit in the head of the screw and use the control switch to regulate the speed of the screwdriver. 4. Refit the depth gauge after removing the screws. 5.3.3 Switching on in sustained operating mode Switch on in sustained operating mode. ▶ 5.3.4 Switching off after sustained operation Press the control switch. ◁ The lockbutton returns to its original position. ▶ 5.3.5 Screwdriver / depth gauge interface 1. Pull the depth gauge away from the power tool, releasing the snap-on connection.
• • • Check all visible parts and controls for signs of damage at regular intervals and make sure that they all function correctly. Do not operate the tool if signs of damage are found or if parts malfunction. Have the tool repaired by Hilti Service immediately. After cleaning and maintenance, refit all guards or protective devices and check that they function correctly.
10 English Printed: 22.10.
Printed: 22.10.
Hilti = registered trademark of Hilti Corp., Schaan Printed: 22.10.
