Operating Instruction DD 350-CA (01)
Table Of Contents
- Original operating instructions
- 1 Information about the documentation
- 2 Safety
- 3 Description
- 4 Technical data
- 5 Operation
- 5.1 Preparations at the workplace
- 5.1.1 Setting up the drill stand
- 5.1.2 Installing the hand wheel
- 5.1.3 Securing the drill stand with an anchor
- 5.1.4 Securing the drill stand by vacuum
- 5.1.5 Adjusting the drilling angle when using the drill stand with combination base plate
- 5.1.6 Extending the rail
- 5.1.7 Installing the spacer
- 5.1.8 Securing the diamond core drilling machine to the drill stand
- 5.1.9 Installing the water supply connection
- 5.1.10 installing the water collection system (accessory)
- 5.1.11 Inserting a diamond core bit
- 5.1.12 Setting the depth gage (accessory)
- 5.2 Types of work
- 5.2.1 Keep the danger zone clear
- 5.2.2 Selecting the speed
- 5.2.3 Portable residual current device (PRCD)
- 5.2.4 Using the hole-starting function
- 5.2.5 Operating the diamond core drilling machine
- 5.2.6 Operating the diamond core drilling machine dry
- 5.2.7 Switching off the diamond core drilling machine
- 5.2.8 Procedure for dealing with a jammed core bit
- 5.2.9 Removing the diamond core bit
- 5.2.10 Removing the diamond core drilling machine
- 5.1 Preparations at the workplace
- 6 Care and maintenance
- 7 Transport and storage
- 8 Troubleshooting
- 9 Disposal
- 10 Manufacturer’s warranty
English 11
5.1.1 Setting up the drill stand
1. Slacken the screw at the top at the brace and the screw at the bottom at the pivot joint of the rail.
2. Bring the rail into the vertical position.
3. Tighten the screw at the top at the brace and the screw at the bottom at the pivot joint of the rail.
4. Install the cover with the integral end stop at the top end of the rail.
5.1.2 Installing the hand wheel
Note
You can install the hand wheel on the right or left side of the carriage on two different shafts.
If you install the hand wheel on the top shaft, the shaft acts directly on the drive of the carriage.
If you install the hand wheel on the bottom shaft, the shaft acts through reduction gearing on the drive
of the carriage.
1. Install the hand wheel on the shaft of your choice on the appropriate side.
2. Secure the hand wheel with the screw.
5.1.3 Securing the drill stand with an anchor
WARNING
Risk of injury The tool may become detached and cause damage if the wrong anchor is used.
▶ Use an anchor suitable for the base material on which you are working and observe the anchor
manufacturer’s instructions. Please contact Hilti Technical Service if you have any questions about
secure fastening.
Printed: 18.10.2017 | Doc-Nr: PUB / 5236055 / 000 / 02