Operating Instruction DD 350-CA (01)
Table Of Contents
- Original operating instructions
- 1 Information about the documentation
- 2 Safety
- 3 Description
- 4 Technical data
- 5 Operation
- 5.1 Preparations at the workplace
- 5.1.1 Setting up the drill stand
- 5.1.2 Installing the hand wheel
- 5.1.3 Securing the drill stand with an anchor
- 5.1.4 Securing the drill stand by vacuum
- 5.1.5 Adjusting the drilling angle when using the drill stand with combination base plate
- 5.1.6 Extending the rail
- 5.1.7 Installing the spacer
- 5.1.8 Securing the diamond core drilling machine to the drill stand
- 5.1.9 Installing the water supply connection
- 5.1.10 installing the water collection system (accessory)
- 5.1.11 Inserting a diamond core bit
- 5.1.12 Setting the depth gage (accessory)
- 5.2 Types of work
- 5.2.1 Keep the danger zone clear
- 5.2.2 Selecting the speed
- 5.2.3 Portable residual current device (PRCD)
- 5.2.4 Using the hole-starting function
- 5.2.5 Operating the diamond core drilling machine
- 5.2.6 Operating the diamond core drilling machine dry
- 5.2.7 Switching off the diamond core drilling machine
- 5.2.8 Procedure for dealing with a jammed core bit
- 5.2.9 Removing the diamond core bit
- 5.2.10 Removing the diamond core drilling machine
- 5.1 Preparations at the workplace
- 6 Care and maintenance
- 7 Transport and storage
- 8 Troubleshooting
- 9 Disposal
- 10 Manufacturer’s warranty
English 7
@
Controls and indicators panel
;
Carrying bar
=
Rating plate
%
Grip
&
Water drainage plug
(
3-way valve
)
Chuck
+
Connector
§
Supply cord guide
/
Water connection
:
Water flow regulator
∙
Supply cord with PRCD
3.2 Controls and indicators panel
@
Gear switch
;
Drilling performance indicator
=
Temperature monitoring/ground fault
%
ON switch
&
OFF switch
(
Rebar button (iron boost)
)
Service indicator
3.3 Vacuum plate (accessory)
@
Vacuum release valve
;
Vacuum hose connector
=
Vacuum seal
%
Pressure gauge
&
Wheel assembly mount
(
Leveling screws (4x)
Printed: 18.10.2017 | Doc-Nr: PUB / 5236055 / 000 / 02