Operating Instruction TE 7-C (01)

English 7
▶ Fit the side handle.
5.2 Fitting / removing the chuck
CAUTION
Risk of injury! The depth gauge, if fitted but not used, might hinder the operator.
▶ Remove the depth gauge from the tool.
Note
The function selector switch should be set to the “Chiseling” position when changing the chuck.
▶ Fit / remove the chuck.
5.3 Fitting / removing the accessory tool
Note
Use of unsuitable grease may cause damage to the product. Use only the recommended grease
supplied by Hilti.
Printed: 10.10.2017 | Doc-Nr: PUB / 5071208 / 000 / 03