Product Technical Guide for MI-DGC-Beam Clamp

Hilti MI/MQ Technical Guide
3.4 MI Components, Allowable Load Data and Specications
Hilti, Inc. (US) 1-800-879-8000 | www.us.hilti.com I en español 1-800-879-5000 I Hilti (Canada) Corp. 1-800-363-4458 I www.hilti.ca I MI/MQ Technical Guide 2015
65
Advantages
• For steel beams with ange thicknesses from 1/8" to
1-7/16" (3 to 36 mm) and ange angle of up to 15°
• Corrosion protection of steel beam is not damaged by
beam clamp
• Beam clamp is equipped with self-locking nuts
Items in set 
MI-DGC Beam clamp for direct connection to steel beam
Items in set 
Fz
Ordering Information
Description For Girder Type Weight Per Set lb (kg) Qty Item No.
MI-DGC 90
 MI-90 7.5 (3.4) 4 233860
MI-DGC 120
 MI-120 8.0 (3.6) 4 233861
Material Specications
Material
Malleable cast iron
Galvanizing
Hot-dip galvanized 2.2 mils (55 μm)
U-bolt
M12, 8.8 grade
5
3
/
16
" (131)
1
1
/
2
" (75)
1" (25)
min.
Fy
Fz
Fx
Technical Data
Allowable loads
1
± Fx (lb) ± Fy (lb) ± Fz (lb)
1010 1010 3900
1 All loads apply to 1 pair. Beam clamps must always be used in pairs positioned on
opposite sides of the ange as shown above.
2 The U-bolt must be positioned against the ange of the steel beam.
3 Tightening torque 62 ft-lb.
Note: For U-bolt dimensions see MIA-BO90 and BO120 items 304840 and 304841 respectively, see page 68.
MI-DGC Beam Clamp