Product Data Sheet for CP 680-P and CP 680-M Cast-in Firestop Device Standoff Components

Hilti Firestop
Saving lives
through innovation
and education
Product Information
Hilti. Outperform. Outlast.
Hilti, Inc. (U.S.) 1-800-879-8000 www.us.hilti.com • www.us.hilti.com/firestop • en español 1-800-879-5000
Hilti (Canada) Corporation 1-800-363-4458 www.hilti.ca • www.hilti.ca/firestop
Floor Device Standoff Component
(for use with CP 680 P/M)
Product description
■ Standoff component provides a pre- or post-poured solution for water
containment and riser clamp support of vertical pipe penetrations.
■ Fully threaded coupler for use with height extensions and assembly of
standoff component to CP 680 P/M.
Product features
■ Standoff component may be installed before or after the concrete is
poured
■ Post poured installation allows oor nisher to work without obstacles
or risk of damaging pre-installed standoffs
■ Designed to meet requirements for a minimum 2" standoff above
substrate surface
■ The completed application can provide an effective solution for re
protection, water containment and riser clamp support for vertical pipe
penetrations*
■ Tested load values according to UL 203
Areas of application
■ Vertical pipe penetrations, metallic and non-metallic
■ Support of vertical pipe clamps for CP 680 P/M
■ Areas subject to ood or needing water containment
* Riser clamp support for CP 680 P/M only. Standoff component may be used with Hilti
Firestop Drop in device CFS-DID for standoff requirements and water containment. Standoff
component is not intended for use with CFS-DID as a load bearing element.
Technical Data* Floor Device
Standoff Component
Dimensions (height)
2 inch diameter: 3.15"
3 inch diameter: 3.15"
4 inch diameter: 3.4"
6 inch diameter: 3.4"
Installed height
(height above coupler after
threading)
2 inch diameter: 2.35"
3 inch diameter: 2.16"
4 inch diameter: 2.32"
6 inch diameter: 2.16"
Minimum Slab Thickness
2 inch diameter: 4.5" slab
3 inch diameter: 5" slab
4 inch diameter: 5.5" slab
6 inch diameter: 5.6" slab
Consistency
Coupler: Polypropylene
Standoff: Metal with plastic overlay
Color
Red
Storage temperature
40 °F (5 °C) to 104 °F (40 °C)
Curing time
Non-curing
Tested in accordance with
ASTM G21
Load Values (maximum allowable)* per UL 203
Standoff diameter lb
Metallic and non-metallic pipes
2 inch 750
3 inch 1050
4 inch 1500
6 inch 2650
*Check local codes and requirements.
Installed CP 680 with coupler and
CFS-DID lid.
Installed CP 680 with standoff
component and CP 680 lid.
Installed CP 680 with standoff
component