ICC ESR-3891 for Self Drilling and Self-Piercing Interior Finishing/Drywall Screws

ICC-ES Evaluation Reports are not to be construed as representing aesthetics or any other attributes not specifically addressed, nor are they to be construed
as an endorsement of the subject of the report or a recommendation for its use. There is no warranty by ICC Evaluation Service, LLC, express or implied, as
to any finding or other matter in this report, or as to any product covered by the report.
Copyright © 2021 ICC Evaluation Service, LLC. All rights reserved. Page 4 of 5
ICC-ES Evaluation Report
ESR-3891 LABC and LARC Supplement
Reissued July 2021
This report is subject to renewal July 2023.
www.icc-es.org | [phone] | [phone] A Subsidiary of the International Code Council
®
DIVISION: 05 00 00—METALS
Section: 05 05 23—Metal Fastenings
DIVISION: 09 00 00—FINISHES
Section 09 22 16.23—Fasteners
REPORT HOLDER:
HILTI, INC.
EVALUATION SUBJECT:
HILTI SELF-DRILLING AND SELF-PIERCING INTERIOR FINISHING/DRYWALL SCREWS
1.0 REPORT PURPOSE AND SCOPE
Purpose:
The purpose of this evaluation report supplement is to indicate that the Hilti Self-drilling and Self-piercing Interior
Finishing/Drywall Screws, described in ICC-ES evaluation report ESR-3891, have also been evaluated for compliance with
the codes noted below as adopted by the Los Angeles Department of Building and Safety (LADBS).
Applicable code editions:
 2020 City of Los Angeles Building Code (LABC)
 2020 City of Los Angeles Residential Code (LARC)
2.0 CONCLUSIONS
The Hilti Self-drilling and Self-piercing Interior Finishing/Drywall Screws, described in Sections 2.0 through 7.0 of the master
evaluation report ESR-3891, comply with the LABC Chapters 22 and 25 and the LARC and are subject to the conditions of
use described in this supplement.
3.0 CONDITIONS OF USE
The Hilti Self-drilling and Self-piercing Interior Finishing/Drywall Screws described in this evaluation report supplement must
comply with all of the following conditions:
 All applicable sections in the evaluation report ESR-3891.
 The design, installation, conditions of use and identification of the Hilti Self-drilling and Self-piercing Interior Finishing/Drywall
Screws are in accordance with the 2018 International Building Code
®
(2018 IBC) provisions noted in the evaluation report
ESR-3891.
 The design, installation and inspection are in accordance with additional requirements of LABC Chapters 16 and 17, as
applicable.
This supplement expires concurrently with the evaluation report, reissued July 2021.