OSHA 1926.1153, Section VI and VII

ManualsBrandsHilti ManualsDiamond Coring MachinesDD 110-W Core drill

HILTI SUBMITTAL PACKAGE

OSHA 1926.1153 TABLE 1,

SECTIONS vi AND vii

Section vi: rig-mounted core saws

or drills

Section vii: handheld and

stand-mounted drills

(including impact and

rotary hammer drills)

Current Hilti handheld and rig-mounted core drills

DD EC-1

DD 110

DD 120

DD 150-U

DD 160

DD 200

DD 250

DD 350

DD 500

DBS • 08/17

For instructions on how to assemble

these systems, please refer to the

Hilti North America Youtube page

Summary of content (7 pages)

PAGE 1
HILTI SUBMITTAL PACKAGE OSHA 1926.
PAGE 2
TABLE 1 REQUIREMENTS These systems fall under either table 1, section vi: handheld and stand-mounted drills (including impact and rotary hammer drills) or section vii: handheld and stand-mounted drills (including impact and rotary hammer drills).
PAGE 3
Core Drill Submittal Check below to see how your system can be compliant with 1926.1153 Table 1. To verify the generation of your tool, check the rating plate, or call Hilti at 800-879-8000 with your serial number.
PAGE 4
SYSTEM OVERVIEW Core drills from Hilti comply either through use of a water delivery system or a shrouded core bit hooked up to a Hilti vacuum. Hilti currently offers the below systems with this configuration: Tool Accessory DD EC-1 (rig mounted) DD 120 DD 150-U (rig mounted) DD 160 DWP 10 handheld water pump DD 200 Any gardena connector with a supplied water attached to Hilti tool DD 250 DD 350 DD 500 Note: previous generations of tools may have different item numbers or nomenclature.
PAGE 5
Core Drill Submittal Tool Accessory Vacuum (use any) VC 125-6 VC 125-9 VC 20-U VC 150-6 X VC 150-6 XE VC 40-U VC 150-10 X VC 40-UE VC 150-10 XE VC 300-17 X DD 110-D DD 120 DD 150-U (handheld) Any DD-X LM core drill bit ** DD 150-U (rig mounted) DD 160 DD 110-D* DWP 10 handheld water pump DD 150-U (handheld)* Any gardena connector with a supplied water attached to Hilti tool * Table 1 does not address handheld core drills being used wet.
PAGE 6
CORING — WET DIA Dust Control — OSHA Hilti developed diamond coring systems are equipped with a water connection which is to be attached to a pressurized water source. When rig‐mounted, these systems are compliant with OSHA 1926.1153, Table 1. Set-up 1. If required, attach the drill stand to the drilling surface using the appropriate anchoring accessories. 2. Attach the water source to the tool. 3. Insert the bit and ensure its tightened by turning the chuck to the closed position. 4. Turn on the water. 5.
PAGE 7
Core Drill Submittal CORING — DRY CORING DIA Dust Control — OSHA Hilti developed dry diamond core drills and bits to be attached to a Hilti vacuum with a filter cleaning mechanism and 99% filter efficiency. Hilti considers these coring applications to fit in, and be in compliance with, OSHA 1926.1153, Table 1, (vii) handheld and stand‐mounted drills (including impact and rotary hammer drills). Set-up 1.