X-W6-12-14 B3 Performance Letter

August 15, 2016
Re: Hilti X-W6 Stud Load Data
To Whom It May Concern:
The X-W6-12-14 B3 F7 fastener has the same design, material and application as the XG-W6-12-14
fastener. Therefore, the allowable loads of XG-W6-12-14 fasteners driven into ASTM A36 steel found in the
attached XG-W6 Stud Fastener Technical Guide Supplement can be applied to X-W6-12-14 B3 F7.
The X-W6-12-24 B3 F7 fastener has the same design, material and application as the XG-W6-12-27. The
X-W6-12-24 B3 F7 fastener has a shorter shank length however the embedment of these two fasteners is
the same. Therefore, the allowable loads of XG-W6-12-27 fasteners driven into Concrete or CMU found in
the attached XG-W6 Stud Fastener Technical Guide Supplement can be applied to X-W6-12-24 B3 F7.
For both X-W6-12-14 B3 F7 and X-W6-12-24 B3 F7, the installation information can be found in Section
1.4 of the attached XG-W6 Stud Fastener Technical Guide Supplement except that the installation tool
should be BX 3-ME.
If you need further information about submittal documents or any questions or concerns, please feel free to
contact the local Hilti technical representatives for further clarification.
Regards,
Chenkai Li, E.I.
Technical Service Consultant
Hilti, Inc.
Attachment: XG-W6 Stud Fastener Technical Guide Supplement
Hilti, Inc.
7250 Dallas Parkway, Suite 1000
Plano, TX 75024
1-800-879-8000
www.hilti.com