ICC ESR-2196 for Self-Drilling and Self-Piercing Screws

ICC-ES Evaluation Reports are not to be construed as representing aesthetics or any other attributes not specifically addressed, nor are they to be construed
as an endorsement of the subject of the report or a recommendation for its use. There is no warranty by ICC Evaluation Service, LLC, express or implied, as
to any finding or other matter in this report, or as to any product covered by the report.
Copyright © 2021 ICC Evaluation Service, LLC. All rights reserved. Page 9 of 10
ICC-ES Evaluation Report
ESR-2196 LABC and LARC Supplement
Reissued October 2021
This report is subject to renewal October 2023.
www.icc-es.org | [phone] | [phone] A Subsidiary of the International Code Council
®
DIVISION: 05 00 00—METALS
Section: 05 05 23—Metal Fastenings
REPORT HOLDER:
HILTI, INC.
EVALUATION SUBJECT:
HILTI SELF-DRILLING AND SELF-PIERCING SCREWS
1.0 REPORT PURPOSE AND SCOPE
Purpose:
The purpose of this evaluation report supplement is to indicate that the Hilti Self-Drilling and Self-Piercing Screws, described
in ICC-ES evaluation report ESR-2196, have also been evaluated for compliance with the codes noted below as adopted by
the Los Angeles Department of Building and Safety (LADBS).
Applicable code editions:
 2020 City of Los Angeles Building Code (LABC)
 2020 City of Los Angeles Residential Code (LARC)
2.0 CONCLUSIONS
The Hilti Self-Drilling and Self-Piercing Screws, described in Sections 2.0 through 7.0 of the evaluation report
ESR-2196, comply with the LABC Chapter 22, and the LARC, and are subjected to the conditions of use described in this
supplement.
3.0 CONDITIONS OF USE
The Hilti Self-Drilling and Self-Piercing Screws described in this evaluation report supplement must comply with all of the
following conditions:
 All applicable sections in the evaluation report ESR-2196.
 The design, installation, conditions of use and identification of the Hilti Self-Drilling and Self-Piercing Screws are in
accordance with the 2018 International Building Code
®
(2018 IBC) provisions noted in the evaluation report ESR-2196.
 The design, installation and inspection are in accordance with additional requirements of LABC Chapters 16 and 17, as
applicable.
 Under the LARC, an engineered design in accordance with LARC Section R301.1.3 must be submitted.
This supplement expires concurrently with the evaluation report, reissued October 2021.