LEED Information for HIT-HY 200-R Fast Cure Hybrid Adhesive

Hilti, Inc.
5400 South 122
nd
East Avenue
Tulsa, OK 74146
1-800-879-8000
www.hilti.com
June 29, 2016
To Whom It May Concern:
Re: Hilti HIT-HY 200-R Adhesive Anchor – LEED Information
Item Numbers:
2022793
2022794
3508711
3543438
The Hilti HIT-HY 200-R Adhesive Anchor is manufactured in Germany.
The amount of post-consumer and post-industrial material in the Hilti HIT-HY 200-R Adhesive Anchor is not known and it cannot be
recycled.
The Hilti HIT-HY 200-R Adhesive Anchor does not contain any Rapidly Renewable Materials.
The VOC content in Hilti HIT-HY 200-R Adhesive Anchor is 13.0 g/l.
The Hilti HIT-HY 200-R Adhesive Anchor is not regulated as a hazardous waste by the Federal EPA Standards.
The regulations for the disposal of non-regulated industrial waste can vary from state to state and even city to city. For this reason,
you should consult your local and state regulatory agencies for direction on disposal.
Please feel free to contact me at [phone] if you have questions.
Sincerely,
Jerry Metcalf MPH, CHMM
Sr. Manager, Safety/Environmental
Hilti Inc
[phone]
[e-mail]
Rev. Date: 6/29/16
The manufacturing plant location on this certificate has been provided for LEEDS reporting purposes only. It should never be used
for Country of Origin certification or a representation of compliance/non-compliance with Buy American or Buy America
requirements, as those requirements differ.
The manufacturing plant location(s) identified on the certificate represent standard Hilti catalog products only. “Specially” produced
non-catalog Hilti products may have differing manufacturing plant locations.
Contact your Hilti representative in cases of “specially” produced products for a custom LEEDS certificates.