ABS Approval 21-2146145-PDA for stainless steel powder-actuated X-CR, X-R and X-ST fasteners

Confirmation of Product Type Approval

Company Name: HILTI AKTIENGESELLSCHAFT

Address: FELDKIRCHERSTR. 100, 9494 SCHAAN, Liechtenstein

Product: Fastening System

Model(s): Stainless powder-actuated Hilti X-CR, X-R and X-ST fasteners

Endorsements:

Certificate Type Certificate Number Issue Date Expiry Date

Product Design Assessment (PDA)

Manufacturing Assessment (MA)

Product Quality Assurance (PQA)

21-2146145-PDA

21-4879051

02-AUG-2021

29-JUL-2021

01-AUG-2026

30-AUG-2026

Tier

3 - Type Approved, unit certification not required

Intended Service

For fastening of fastened materials to the base materials of carbon steel, stainless steel, or aluminum, in

the Marine, Offshore and Industrial environment.

Description

General Purpose Fasteners: X-CR, X-R

Threaded Studs: X-ST

Stainless Steel Threaded Studs, and Nails whereby fastenings are made by using powder actuated tools

to drive the fasteners into their final positions, by displacing base material in the process.

Ratings

For Rating Matrix and Product Test Reports refer to ABS Type Approval Certificate and Hilti Direct

Fastening Technology Manual for each product.

Service Restrictions

Unit Certification is not required for this product. If the manufacturer or purchaser's request an ABS

Certificate for compliance with a specification or standard, the specification or standard, including

inspection standards and tolerances, must be clearly defined.

List of Recommended Areas and Applications:

1. The Hilti DX Fastenings are to be used for fastened and base material of carbon steel, stainless steel,

and aluminum in the marine, offshore, and industrial environments, as applicable (Ref to: Product

Matrix).

PAGE 1
Confirmation of Product Type Approval Company Name: HILTI AKTIENGESELLSCHAFT Address: FELDKIRCHERSTR.
PAGE 2
Certificate Number: 21-2146145-PDA 2. To ensure that proper anchoring/fastening mechanisms take place, i.e. clamping, keying, fusing, and brazing/soldering, besides the use of proper fastening tools and power source, the following base material strengths are to comply with; Carbon Steel : Ultimate Tensile Strength fu = 370 N/mm2 (53.53 ksi ) Stainless Steel : Ultimate Tensile Strength fu = 370 N/mm2 (53.53 ksi ) Aluminum : Ultimate Tensile Strength fu = 200 N/mm2 (28.94 ksi ) 3.
PAGE 3
Certificate Number: 21-2146145-PDA g) In locations particularly susceptible to corrosion. *Hilti fasteners often may be used for the listed applications by following the Manufacturer's recommendations and guidance. The attending Surveyor and Owner are to be consulted and agree with the use of the fasteners 6. Hilti fasteners may also be used for additional applications other than those listed above. Some applications may require an engineering review in advance.
PAGE 4
Certificate Number: 21-2146145-PDA NA Other Standards Manufacturer's Standards Corporate ABS Programs American Bureau of Shipping Print Date and Time: 06-Sep-2021 7:26 ABS has used due diligence in the preparation of this certificate, and it represents the information on the product in the ABS Records as of the date and time the certificate is printed.