Operating Instruction SD 4500 (01)

English 9
:
Charge state and fault display
(Li-ion battery)
∙
Battery release buttons
$
Depth gauge
3.2 Intended use
The product described is a hand-held cordless electric tool, equipped with
a clutch, for use in drywall installation work.
The power tool is designed for driving and removing screws in drywall
installation work. Drywall screws with a length of up to 55 mm and a
diameter of up to 4.2 mm can be used.
Do not use the product to work with materials hazardous to the health (e.g.
asbestos)
▶ Use only Hilti Liion batteries from the B 18 / B 22 series with this product.
▶ Use only Hilti battery chargers of the C4/36 series for charging these
batteries.
3.3 Charge state display
The charge state of the Liion battery is displayed after pressing one of the
release buttons lightly (press only until slight resistance is felt).
Status Meaning
4 LEDs light. Charge state: 75 % to 100 %
3 LEDs light. Charge state: 50 % to 75 %
2 LEDs light. Charge state: 25 % to 50 %
1 LED lights. Charge state: 10 % to 25 %
1 LED blinks. Charge state: < 10 %
Battery charge state cannot be displayed while the control switch is
pressed and for up to 5 seconds after releasing the control switch.
3.4 Items supplied
Drywall screwdriver, depth gauge, bit holder, bit, operating instructions
Other system products approved for use with this product can be found at
your local Hilti Store or at: www.hilti.group.
3.5 Overloading and overheating protection
The drywall screwdriver is protected from overloading and overheating by an
automatic cut-out. Overloading or overheating is indicated by the four LEDs
blinking. After overheating, when the control switch is pressed to restart the
screwdriver, there may be a delay before the screwdriver restarts.
Printed: 15.07.2019 | Doc-Nr: PUB / 5295850 / 000 / 02