Operating Instruction SD 4500 (01)

14 English
3. Position the screw on the bit and bring the tip of the screw into contact
with the working surface.
4. Use the control switch to regulate the speed of the screwdriver.
6.2 Removing screws
1. Pull the depth gauge off.
2. Set the screwdriver to reverse rotation.
3. Insert the bit in the head of the screw and use the control switch to
regulate the speed of the screwdriver.
4. Refit the depth gauge after removing the screws.
6.3 Switching on in sustained operating mode
▶ Switch on in sustained operating mode.
6.4 Switching off after sustained operation
▶ Press the control switch.
➥ The lockbutton returns to its original position.
6.5 Screwdriver / depth gauge interface
1. Pull the depth gauge away from the power tool, releasing the snap-on
connection.
Printed: 15.07.2019 | Doc-Nr: PUB / 5295850 / 000 / 02