Operating Instruction TE 60 (04)
Table Of Contents
- Original operating instructions
- Mode d'emploi original
- 1 Indications relatives à la documentation
- 2 Sécurité
- 3 Description
- 4 Caractéristiques techniques
- 5 Utilisation
- 6 Nettoyage et entretien
- 7 Transport et entreposage
- 8 Aide au dépannage
- 9 Recyclage
- 10 Garantie constructeur
- Manual de instrucciones original
- 1 Información sobre la documentación
- 2 Seguridad
- 3 Descripción
- 4 Datos técnicos
- 5 Manejo
- 6 Cuidado y mantenimiento
- 7 Transporte y almacenamiento
- 8 Ayuda en caso de averías
- 9 Reciclaje
- 10 Garantía del fabricante
- Manual de instruções original
- 1 Indicações sobre a documentação
- 2 Segurança
- 3 Descrição
- 4 Características técnicas
- 5 Utilização
- 6 Conservação e manutenção
- 7 Transporte e armazenamento
- 8 Ajuda em caso de avarias
- 9 Reciclagem
- 10 Garantia do fabricante
*2134961*
2134961 English 11
5.2.2 Drilling without hammering
Drilling without hammering action is possible when accessory tools with
a special connection end are used. Accessory tools of this kind are
available from Hilti. Alternatively, when the keyless quick-release chuck
is fitted, smooth-shank drill bits for wood or steel, for example, can be
used to drill without hammering.
▶
Set the function selector switch to this symbol: .
5.3 Chisel positioning 8
CAUTION
Risk of injury! Loss of control over the chisel direction.
▶ Do not operate the tool when the selector switch is set to “Chisel
positioning”. Turn the function selector switch until it engages in the
“Chiseling” position.
The chisel can be adjusted to 24 different positions (in 15° increments).
This ensures that flat chisels and shaped chisels can always be set to
the optimum working position.
1.
Set the function selector switch to this symbol: .
2. Rotate the chisel to the desired position.
3.
Set the function selector switch to this symbol: until it engages.
▶ The product is ready for use.
5.3.1 Chiseling 9
▶
Set the function selector switch to this symbol: .
5.3.2 Switch sustained operation on and off 10
When chiseling, the control switch can be locked in the “on” position.
1. Push the lockbutton for continuous operation forward.
2. Press the control switch fully.
▶ The product then runs in sustained operating mode.
3. Push the lockbutton for continuous operation back.
▶ The product switches off.