OSHA 1926.1153, Section VII (1)

HILTI SUBMITTAL PACKAGE

OSHA 1926.1153 TABLE 1,

SECTION vii

Section vii: Handheld and

stand-mounted drills

(including impact and

rotary hammer drills)

Current Hilti rotary hammers that use a DRS-S shroud:

TE 2 (and 2-S)

TE 3-C

TE 7

TE 4-A 22

TE 6-A 36

TE 7-C

TE 30 (and 30-C)

TE 40-AVR

TE 50-AVR

TE 60-AVR

TE 60-ATC/AVR

TE 70-AVR

TE 70-ATC/AVR

TE 80-ATC/AVR

DBS • 08/17

For instructions on how to assemble

these systems, please refer to the

Hilti North America Youtube page

DRS-S

PAGE 1
HILTI SUBMITTAL PACKAGE OSHA 1926.
PAGE 2
TABLE 1 REQUIREMENTS These systems fall under table 1, section vii: handheld and stand-mounted drills (including impact and rotary hammer drills).
PAGE 3
DRS-S Submittal SYSTEM OVERVIEW Hilti rotary hammers with a DRS-S are table 1 compliant through use of a dust collection shroud hooked up to a vacuum that meets table 1 requirements. This shroud attaches to the depth gauge on the tool, and must be purchased separately for tools with an SDS-max connection. Any Hilti rotary hammer with a depth gauge will be table 1 compliant with the DRS-S if a Hilti vacuum is used.
PAGE 4
Tool Accessory Vacuum (use any) TE 50-AVR VC 125-6 VC 125-9 VC 20-U VC 150-6 X VC 150-6 XE VC 40-U VC 150-10 X VC 40-UE VC 150-10 XE VC 300-17 X TE 60-AVR TE 60-ATC/AVR TE 70-AVR Depth gauge (sold separately) DRS-S TE 70-ATC/AVR TE 80-ATC/AVR Note: previous generations of tools may have different item numbers or nomenclature.
PAGE 5
DRS-S Submittal DRILLING — ROTARY HAMMER DRILLS AND COMBI-HAMMERS TE Dust Control — OSHA Hilti developed drilling dust collection systems with a shroud, to be attached to a Hilti vacuum with a filter cleaning mechanism and 99% filter efficiency, compliant with OSHA 1926.1153, Table 1. Set-up 1. Attach the appropriate dust collection shroud to the drill. 2. Insert the bit. Rotate the bit in the chuck until you hear a clicking noise to verify that the bit is firmly inserted into the chuck. 3.