OSHA 1926.1153, Section X and VII

HILTI SUBMITTAL PACKAGE

OSHA 1926.1153 TABLE 1,

SECTION x AND SECTION vii

Section x: Jackhammers and handheld

powered chipping tools

Section vii: Handheld and stand-mounted drills

(including impact and

rotary hammer drills)

Current Hilti SDS-max rotary hammers that use a DRS-Y shroud:

TE 50-AVR

TE 60-AVR

TE 60-ATC/AVR

TE 70-AVR

TE 70-ATC/AVR

TE 80-ATC/AVR

DBS • 08/17

For instructions on how to assemble

these systems, please refer to the

Hilti North America Youtube page

DRS-Y

PAGE 1
HILTI SUBMITTAL PACKAGE OSHA 1926.
PAGE 2
TABLE 1 REQUIREMENTS These systems fall under table 1, section x: jackhammers and handheld powered chipping tools and section vii: handheld and stand-mounted drills (including impact and rotary hammer drills).
PAGE 3
DRS-Y Submittal Check below to see how your system can be compliant with 1926.1153 Table 1. To verify the generation of your tool, check the rating plate, or call Hilti at 800-879-8000 with your serial number. To check fit of the DRS-Y with older tool generations, check the sticker on the inside of the case on the DRS-Y, or refer to the instruction manual.
PAGE 4
DRILLING — ROTARY HAMMER DRILLS AND COMBI-HAMMERS TE Dust Control — OSHA Hilti developed drilling dust collection systems with a shroud, to be attached to a Hilti vacuum with a filter cleaning mechanism and 99% filter efficiency, compliant with OSHA 1926.1153, Table 1. Set-up 1. Attach the appropriate dust collection shroud to the drill. 2. Insert the bit. Rotate the bit in the chuck until you hear a clicking noise to verify that the bit is firmly inserted into the chuck. 3.