CAD Details for Strut Fastened with S-BT to Bottom / Top Flange

*
Drawn
Date
Drawing No.
Index Sheet
DescriptionProject
Developer
Information and loads are recommendations for static application, and based on the published data in the Hilti
Technical Guide (including allowable load values, factors of safety, methods of calculation and limiting factors).
The responsible project engineer must verify suitability for any specific application. Modification to design may
alter performance and should be evaluated by engineer of record.
HAM/JGB RPB
23 NOV 2016
12-122-04
E 1/1
DETAILS FOR ELECTRICAL
ENGINEERS
STRUT FASTENED WITH S-BT
TO BOTTOM/TOP FLANGE
STRUT FASTEN TO BOTTOM FLANGE (OVERHEAD)
NOTE:
1. SPACE S-BT STUDS ACCORDINGLY TO ACCOMMODATE DESIGN LOADS.
MINIMUM OF TWO STUDS PER STRUT SECTION.
2. S-BT STUDS SHALL BE INSTALLED PER HILTI INSTALLATION
INSTRUCTIONS.
3. S-BT STUDS SHALL BE INSTALLED AT CENTERLINE OF OPEN FULL SLOT.
CONTACT HILTI ENGEERING FOR THINNER BASE MATERIAL
**
S-BT-MR W10/15 SN6 - PACKAGE INCLUDES SERRATED FLANGE NUTS.
STRUT FASTEN TO TOP FLANGE
U.V. RESISTANT SEALING
WASHER WITH STAINLESS
STEEL COVER
HILTI HS-158 STRUT
HILTI HS-158 STRUT
HILTI HS-158 STRUT
ASTM A36 OR ASTM A572 GRADE 50 STEEL T ≥ 1/4 IN.*
ASTM A36 OR ASTM A572 GRADE 50 STEEL T ≥ 1/4 IN.*
Hilti S-BT-MR W10/15 SN6 SCREW-IN
THREADED STUD WITH HILTI
STAINLESS STEEL SERRATED FLANGE NUT**
Hilti S-BT-MR W10/15 SN6 SCREW-IN
THREADED STUD WITH HILTI
STAINLESS STEEL SERRATED FLANGE NUT**
Hilti S-BT-MR W10/15 SN6 SCREW-IN
THREADED STUD WITH HILTI
STAINLESS STEEL SERRATED FLANGE NUT**