Operating Instruction TE 30-AVR

8 English 2143374
*2143374*
For safe, reliable operation, use only genuine Hilti spare parts and
accessories. Spare parts, accessories and consumables approved by
Hilti for use with this product can be found at your Hilti Center or at
www.hilti.com.
4 Technical data
For rated voltage, rated current, frequency and/or input power, refer to
the country-specific type identification plate.
If the device is powered by a generator or transformer, the generator or
transformer’s power output must be at least twice the rated input power
shown on the rating plate of the device. The operating voltage of the
transformer or generator must always be within +5 % and -15 % of the rated
voltage of the device.
TE 30 TE 30AVR
Weight
9.0 lb
(4.1 kg)
9.3 lb
(4.2 kg)
Ø Hammer drill bits
3/16 in … 1 1/16 in 3/16 in … 1 1/16 in
Ø Hammer drill bits
4 mm … 28 mm 4 mm … 28 mm
Ø drill bits for wood
3/16 in … 1 in 3/16 in … 1 in
Ø drill bits for wood
3 mm … 25 mm 3 mm … 25 mm
Ø drill bits for metal
3/16 in … 1/2 in 3/16 in … 1/2 in
Ø drill bits for metal
3 mm … 13 mm 3 mm … 13 mm
5 Using extension cords
WARNING
A damaged supply cord presents a hazard! Do not touch the supply cord
or extension cord if damaged while working. Disconnect the supply cord
plug from the power outlet.
▶ Check the appliance’s supply cord at regular intervals and have it
replaced by a qualified specialist if found to be damaged.
• Use only extension cords of a type approved for the application and
with conductors of adequate gauge (cross section). The power tool
may otherwise suffer a drop in performance and the extension cord may
overheat.
• Check the extension cord for damage at regular intervals.
• Replace damaged extension cords.
• When working outdoors, use only extension cords that are approved and
correspondingly marked for this application.