Operating Instruction AG 500-11S (05)

Table Of Contents

2 English 2141935

*2141935*

This symbol is intended to draw special attention to certain points

when handling the product.

Wireless data transfer

1.3 Product-dependent symbols

1.3.1 Symbols on the product

The following symbols are used on the product:

Wear eye protection.

Revolutions per minute

Rated speed

Diameter

Protection class II (double-insulated)

1.4 Product information

Hilti products are designed for professional use and may be operated, ser-

viced and maintained only by trained, authorized personnel. This personnel

must be informed of any particular hazards that may be encountered. The

product described and its ancillary equipment may present hazards when

used incorrectly by untrained personnel or when used not as directed.

The type designation and serial number are printed on the rating plate.

▶ Write down the serial number in the table below. Always quote this

information when you contact a Hilti representative or Hilti Service to

enquire about the product.

Product information → page 2

Product information

Angle grinder AG 500-11S

Generation 05

Serial no.

1.5 Declaration of conformity

We declare, on our sole responsibility, that the product described here

complies with the applicable directives and standards. A copy of the

declaration issued by the certification department can be found at the end

of this documentation.

The technical documentation is filed here:

Hilti Entwicklungsgesellschaft mbH | Tool Certification | Hiltistrasse 6 | 86916

Kaufering, Germany

Printed: 19.10.2018 | Doc-Nr: PUB / 5402266 / 000 / 01