Operating Instruction AG 500-11S (05)
Table Of Contents
- Original operating instructions
- 1 Information about the documentation
- 2 Safety
- 3 Description
- 3.1 Overview of the product
- 3.2 Intended use
- 3.3 Items supplied
- 3.4 Starting current limiter
- 3.5 Constant-speed electronics
- 3.6 Active Torque Control (ATC)
- 3.7 Restart interlock
- 3.8 Temperature-dependent product protection
- 3.9 Front cover for the disc guard
- 3.10 DG-EX 125/5 dust hood for grinding (accessory)
- 3.11 DC-EX 125/5M dust hood for grinding (accessory)
- 3.12 DC-EX 125/5C dust hood for cutting (accessory)
- 4 Consumables
- 5 Technical data
- 6 Before use
- 7 Operation
- 8 Care of the product
- 9 Transport and storage
- 10 Troubleshooting
- 11 Disposal
- 12 Manufacturer’s warranty
20 English
6.3 Fitting or removing the front cover
1. Position the front cover with the closed side on the standard guard and
push it on until it engages.
2. To remove it, release the catch for the front cover and then lift the front
cover away from the standard guard.
6.4 Fitting or removing the discs
CAUTION
Risk of injury. The accessory tool may be hot.
â–¶ Wear protective gloves when changing the accessory tool.
Diamond discs must be replaced when their cutting or grinding perfor-
mance drops significantly. This generally is the case when the diamond
segments reach a height of less than 2 mm (1/16").
Other discs must be replaced when their cutting performance drops
significantly or other parts of the angle grinder (not the disc) come into
contact with the material you are working on.
Abrasive discs must be replaced when their expiry date has been
reached.
Printed: 19.10.2018 | Doc-Nr: PUB / 5402264 / 000 / 01