ICC ESR-3027 for Kwik HUS-EZ Screw Anchors in Concrete

ICC-ES Evaluation Reports are not to be construed as representing aesthetics or any other attributes not specifically addressed, nor are they to be construed
as an endorsement of the subject of the report or a recommendation for its use. There is no warranty by ICC Evaluation Service, LLC, express or implied, as
to any finding or other matter in this report, or as to any product covered by the report.
Copyright © 2021 ICC Evaluation Service, LLC. All rights reserved. Page 20 of 20
ICC-ES Evaluation Report
ESR-3027 FBC Supplement
Reissued December 2019
Revised April 2021
This report is subject to renewal December 2021.
www.icc-es.org | [phone] | [phone] A Subsidiary of the International Code Council
®
DIVISION: 03 00 00—CONCRETE
Section: 03 16 00—Concrete Anchors
DIVISION: 05 00 00—METALS
Section: 05 05 19—Post-Installed Concrete Anchors
REPORT HOLDER:
HILTI, INC.
EVALUATION SUBJECT:
HILTI KH-EZ, KH-EZ P, KH-EZ PM, KH-EZ PL, KH-EZ C, KH-EZ E, KH-EZ I, AND KH-EZ CRC CARBON STEEL SCREW
ANCHORS AND KH-EZ SS316 AND KH-EZ C SS316 STAINLESS STEEL SCREW ANCHORS FOR USE IN CRACKED
AND UNCRACKED CONCRETE
1.0 REPORT PURPOSE AND SCOPE
Purpose:
The purpose of this evaluation report supplement is to indicate that Hilti KH-EZ, KH-EZ P, KH-EZ PM, KH-EZ PL, KH-EZ C,
KH-EZ E, KH-EZ I, and KH-EZ CRC carbon steel screw anchors and KH-EZ SS316 and KH-EZ C SS316 stainless steel screw
anchors in cracked and uncracked concrete, described in ICC-ES evaluation report ESR-3027, have also been evaluated for
compliance with the codes noted below:
Compliance with the following codes:
 2020 Florida Building Code—Building
 2020 Florida Building Code—Residential
2.0 CONCLUSIONS
The Hilti KH-EZ, KH-EZ P, KH-EZ PM, KH-EZ PL, KH-EZ C, KH-EZ E, KH-EZ I, and KH-EZ CRC carbon steel screw anchors
and KH-EZ SS316 and KH-EZ C SS316 stainless steel screw anchors, described in Sections 2.0 through 7.0 of the evaluation
report ESR-3027, comply with the Florida Building Code—Building and the Florida Building Code—Residential, provided the
design requirements are determined in accordance with the Florida Building Code—Building or the Florida Building Code—
Residential, as applicable. The installation requirements noted in ICC-ES evaluation report ESR-3027 for the 2018
International Building Code
®
meet the requirements of the Florida Building Code—Building or the Florida Building Code—
Residential, as applicable.
Use of the Hilti KH-EZ, KH-EZ P, KH-EZ PM, KH-EZ PL, KH-EZ C, KH-EZ E, KH-EZ I, and KH-EZ CRC carbon steel screw
anchors, and KH-EZ SS316 and KH-EZ C SS316 stainless steel screw anchors in cracked and uncracked concrete have also
been found to be in compliance with the High-Velocity Hurricane Zone provisions of the Florida Building Code—Building and
the Florida Building Code—Residential, with the following condition:
a) For anchorage to wood members, the connection subject to uplift, must be designed for no less than 700 pounds (3114 N).
For products falling under Florida Rule 61G20-3, verification that the report holder’s quality assurance program is audited by
a quality assurance entity approved by the Florida Building Commission for the type of inspections being conducted is the
responsibility of an approved validation entity (or the code official, when the report holder does not possess an approval by the
Commission).
This supplement expires concurrently with the evaluation report, reissued December 2019 and revised April 2021.